Sheet metal tutorial | UNBEND with References, Deformations, Distinct Areas in Creo Parametric
HTML-код
- Опубликовано: 21 авг 2024
- Learn about Sheet metal UNBEND in details in Creo Parametric
Transitional unbend
• Sheet metal tutorial |...
Crossection driven unbend
• Sheet metal tutorial |...
You’re awesome! Thank you so much for sharing this.
Glad it was helpful!
Very nice Sir
Hi sir,
One doubt!
In manufacturing world is it possible to do bend forming without any corner relief?
Yes it's possible. Stainless steel Kitchen Sink is the practical example.
Thank you sir
How to bend back the corner bends you created using split area and rip?
You need to follow this technique.
ruclips.net/video/s2ST9LJX970/видео.html
Super
Thanks for all your comments.
@@CADxTraining sir please explain some sheet metal assembly part design with detailing
@@CADxTraining sir your some procedure for design parts fails in creo3.0
Is it 3.0 suitable for sheet metal design or not sir
@@kbnchannel1991 This part is actually done in creo 3. It should not fail. Check your procedure once.
@@CADxTraining I done base part by extrude and convert to sheetmetal and side wall by flange, then corners are flatten by cross driven unbend but final flat pattern fails sir
Kindly give the dish unbend in sheet metal
This will be helpful.
ruclips.net/video/7OVjlp_bG8U/видео.html
How to make flange in angle planner
I didn't get your question.
how to u did that shell wall
Just watch this. You will get the answer. ruclips.net/video/P2ZsYE0YT_4/видео.html