Nice, I am curious about some measurement results relating to output power vs input power. You could use the good old Prony brake with two calibrated force measurement cells for torque measurements. When you use disk magnets you can also use circular coils. They are considerably easier to make. Furthermore you can use Iron (or low carbon steel) rings at the opposite side of the rotor disks to make a yoke to bridge the magnets in order to increase the magnetic flus in the air gaps. In this way you can also get lower magnetic flux pertubations around the motor.
I watch similar videos and always wonder the same thing... Everyone makes winders for filament that lay it down precisely on the reel, but none of these motor makers makes a winder to neatly of turns for their motors. What gives? You are obviously creative enough to make a motor, and you know it needs wound precisely, so let's see you complete the circle...
Wonderful job. Very meticulous work :)
🎉❤❤ u r very brave boy. Such strong hands to withsstand that BEAST of. Motor
Thanks ❤
Good job. May I know Why 8 magnets 12 coils? Thanks for sharing ❤
Nice, I am curious about some measurement results relating to output power vs input power. You could use the good old Prony brake with two calibrated force measurement cells for torque measurements. When you use disk magnets you can also use circular coils. They are considerably easier to make. Furthermore you can use Iron (or low carbon steel) rings at the opposite side of the rotor disks to make a yoke to bridge the magnets in order to increase the magnetic flus in the air gaps. In this way you can also get lower magnetic flux pertubations around the motor.
Can I use it as an alternative to an e-bike?
👍🏼👍🏽👍🏿👏👏👏
What type of motor is that? Single phase, 3-phase, or Synchronous? I already know Just seeing if anyone else knows.
3 phase
I watch similar videos and always wonder the same thing... Everyone makes winders for filament that lay it down precisely on the reel, but none of these motor makers makes a winder to neatly of turns for their motors. What gives? You are obviously creative enough to make a motor, and you know it needs wound precisely, so let's see you complete the circle...
What is the COP?
i m first
Я второй.
can you please help me in stator winding and connection or how can i connect to you?
How did you make that magnet? Pls make a tutorial
I think it is a 3D printed support with magnets.
What's the maximum RPM?
Can u please provide a name of materials did you used and how to connect each wire
3d printed files stl please