The yellow is the ignition wire from the ignition coil. Voltage through that fluctuates with the engine RPM. For an engine without a separate lighting coil (this one), you have to go straight to the battery for the positive connection (via a switch obviously). Negative side can go to any grounded wire or surface that's connected to the negative pole on the battery. The light will work independently of the engine (running or not) and be completely steady in brightness. Only downside is that you have to remember to turn it off or you'll drain the battery. Nice light! You've inspired me to put one on my 110L.
from the light run the postive to the switch and another seperate postive from the switch to the battery and the negative from the light to the battery
You need to put a resistor in with the wiring. Your bike is running A.C. those lights are DC. That will stop the flicking. Had to do this for the 24hr bark buster race up there in NY on my 300 xc
So i have an 03 flywing mx 100. Its a pw80 clone with a honda 50cc stroked and bored to be a 100cc and i just picked it up for 20 bucks. All i had to do was remove rust from the rear drum and replace the coil. This is my first bike and i was wondering if anybody can give me advice on the best upgrades. Thanks
Best exhaust for my 140cc yx everything is upgraded thing it has 20hp has z40 cam race flywheel race piston ooracing wiring with rev limiter ported aswell what exhaust for 70 or lower should I get
I have a light same as that mounted on my pitbike and I have it between my number board and mudguard I'll try post a picture or I'll set it as my display pic
The yellow is the ignition wire from the ignition coil. Voltage through that fluctuates with the engine RPM. For an engine without a separate lighting coil (this one), you have to go straight to the battery for the positive connection (via a switch obviously). Negative side can go to any grounded wire or surface that's connected to the negative pole on the battery. The light will work independently of the engine (running or not) and be completely steady in brightness. Only downside is that you have to remember to turn it off or you'll drain the battery. Nice light! You've inspired me to put one on my 110L.
from the light run the postive to the switch and another seperate postive from the switch to the battery and the negative from the light to the battery
If u use hose clamps it might hold it better than zip ties! Looks sick though
Loving the pit bikes videos lately
LOVE YOUR EVERYDAY VLOGGING AND COOL SETUP
Yes its snowing love winter vlogs.Love all your vids!
Keep doing videos like this, I've been watching your videos for a really long time and I like seeing videos like this more than just riding.
You need to put a resistor in with the wiring. Your bike is running A.C. those lights are DC. That will stop the flicking. Had to do this for the 24hr bark buster race up there in NY on my 300 xc
Yo if you guys ever come up to ny we got some spots to ride to. Hit me for the snap but shit wouldnt mind riding with these guys for a day lol
i love the totally random vlogs just to mix it up a bit.
All blue looks way better... like if you agree
Hey tyler. Can you make Full video of how you make the stickers. I mean everything on the stickers. That would be really cool😉 please😊
Doesn’t matter what you post, I enjoy anything you upload!
I love the longer vlogs!
i love these type of this videos
The blue graphics look sick af!!!!
All your vid's rock my dude ... Keep mixing it up ....
I love this channel great vids keep it up
You make the best videos ever you should keep vlogging every day you have sick dirt bikes you make riding look easy and make perfect riding videos
love this video dude!
Definitely looking forward to the 50 build and the 125 build
Just move the mount bracket to the top of your bar clamps (in between each side of the bars) so if sits better
Your vlogs are the best 🏍👍
I like all the content you bring !
The blue plastics look sick!
If u can try and fit 2018 Kx250f front fender and no. plate on the kx125 and get hand guards for the klx110. Like please so Tyler can see
Awesome video man as always! I like all the content that you make so any vid is great! :)
I like the all blue too
I love the vlogging but just do what makes you happy
Ryan’s bike looks sick now
Is a 2007 kx250f with brand new wiseco top end for $1600 a good deal???
Mike Cast Depends on the condition
Mike Cast exactly I do motovlogs but anyways if it’s been maintained go for it
if it runs good and looks good then yes
Mike Cast No jk yes lol
Yup
Everything looks peak tyler
Been here since 70 subs.... notification squad
you know your getting somewhere when officially have a notifications sqaud
Blue looks sick
what kind of sticker machine do u use
Love building content and content like this
Those blue plastics look mint
i love these put always talki about your bike and what you want to do to your bike and what your dream bike is and stuff
Do a twin exhaust on the Pit bike
every day vlogs and dirt bike videos man
You should do a video on all the mods you have done on your pit bike
the building vids are good to watch
Yes do more videos like this and also your normal content
Keep doing what your doing 🤘🏼🤘🏼
You could have put the mount on top of the handkebar mount to raise it a bit!👍
The videos are great, I think you should keep on doing what your'e doing.
It looks so much better all blue
I like the blue plastics on the Yamaha
I love these videos
Love all the content
Blue looks sick keep it
I like the building vlogs but I also like the dirt bike ones
Good video as always 🙂
Love your vids
Can I have the handguards
Tyler Monagan put disk brake's on the KLX110
Yes I really like the building vids
KEEP UP THE DAILY UPLOADS
I didnt understand how he connected the led bar i want to know so i can do it too
he needs to do a video of how he or ryan wired the light.
nice plastic blue looks good
His bike looks sick
do a vid on how bright the light bar is
Did you hook up the light to a rectifier or did you hook it up to a motorcycle battery
You’re the best zip ties guy
I would like if you did more videos about the kx 125
loveing the blue
Do a garage build!
All blue is sick
which bend are those renthal bars? 50cc playbike bend or 110cc playbike bend?
Hi Tyler huge fan!
i like the building tyler.
So I'm new to pit bikes I just picked up a coolster manual 4 speed very fast did I do good
The heater is really annoying and I think next thing done to ur truck should be lift with tires and rims
Love the building vlogs
You are a legend
Love your blog
What's the go with the can am in the background
Lit bar looks sick
So i have an 03 flywing mx 100. Its a pw80 clone with a honda 50cc stroked and bored to be a 100cc and i just picked it up for 20 bucks. All i had to do was remove rust from the rear drum and replace the coil. This is my first bike and i was wondering if anybody can give me advice on the best upgrades. Thanks
Best exhaust for my 140cc yx everything is upgraded thing it has 20hp has z40 cam race flywheel race piston ooracing wiring with rev limiter ported aswell what exhaust for 70 or lower should I get
How did you solve the issue of the light only working when you rev the engine
Love that blue
You need a rectifier to hook up a light
I knew it you would like the light bar, I have the same one.
do some more quading videos please with the raptor 350 you never use
Get a black and red rental bar pad
Where did get that mount that’s zip tied on?
Thyre sick tyler
Love your video's Braap
What kind of stick printer is that?
i have a klx 140. i mounted it to my haldelbar mount
I have a light same as that mounted on my pitbike and I have it between my number board and mudguard I'll try post a picture or I'll set it as my display pic
I wanna see more vids like this
Ive got a 1993 Xr100r and i drilled a hole through my handle bars. I bought a battery and wired it to that with a switch on my handle bars
Im aware the hole isnt my safest bet
Where did you get the graphics for the pitty at?
I’m late but better now than never🤟🏽
little brother?
hey tyler i live about 2 and a half hours away from you and i was on craigslist looking at sleds and someone has yours up for sale
I really liked this vid
when u bye parts go through @rocky mountain atv mc it tacks 3 days shipping all over the world
wanna see more bike build or anything builds
I have the same light and switch of my three wheeler