What kind of motor do you using? Voltage? Amps? Maybe some torque diagram? I've a very big r/c car and I'm looking for some electric solution for it. Thanks a lot!
I wrecked an old forklift about 1950 60 era, the motor out of that was about 2 foot long, it had 2 motors one for drive and the other for the hydraulic pump
Check "IGBT drivers by subcooledheatpump " but use a pwm speed-control made with a micro controller such as an Arduino, the 555 timer chip did not work for me.
Yes! This was actually my original intent for it.. I have an old FL250 that I have modified the gear box on it to fit this motor's spline but haven't gotten around to finishing the project. Hopefully restart this project soon though...
What kind of motor do you using? Voltage? Amps? Maybe some torque diagram? I've a very big r/c car and I'm looking for some electric solution for it. Thanks a lot!
I find that battery so small. Is that the original battery for the clarck?
Hey mate whats the name of the motor and can I run it on 72v?
cheers
Very nice motor mate. Nice to see you using the good igbts ;-)
Thanks for sharing'
~☆~☆~☆~Thumbs up~☆~☆~☆~
I wrecked an old forklift about 1950 60 era, the motor out of that was about 2 foot long, it had 2 motors one for drive and the other for the hydraulic pump
what volt motor is that? 12v? 24v? may be doing this to a buggy
Nice IGBT H bridge setup, but I would rather use a pwm speed-control made with a micro controller such as an Arduino, the 555 did not work for me.
Qué bonito suena!!!
Name this for kilometer what motor name
Is there a diagram of the circuit I could get please
Check "IGBT drivers by subcooledheatpump
" but use a pwm speed-control made with a micro controller such as an Arduino, the 555 timer chip did not work for me.
Be careful running a series wound DC motor with no load, the armature could literally explode from spinning to fast.
TTLLOGIC I'm using a forklift motor for my boat do you think I would have a problem since there is not much load from the propeller?
How's your boat?
@@josh.w7480 props are a HUGE load, when in the water...
@@josh.w7480 The blades will have to battle the water.So ,the water IS the load.
i would also love to see this diagram. thanks
Off a 555 chip !
hello can you share schematic circuit & electronic component to me?
Why is there not audio??
You could use the motor for a go kart!
Yes! This was actually my original intent for it.. I have an old FL250 that I have modified the gear box on it to fit this motor's spline but haven't gotten around to finishing the project. Hopefully restart this project soon though...
Le prix de l'ensemble
muito bom coloca o esquema eletrico pra nos ai.
Liquor named forklift motor this one Google searching
Plz donate this moter
I work on forklifts so what was ur point here.
Wow big guy here. Look everyone, elvis works on forklifts.😂😂🖕
Aap bahut acchi lagi aap apna contact number
moter name and madil number
Very nice motor mate. Nice to see you using the good igbts ;-)
Thanks for sharing'
~☆~☆~☆~Thumbs up~☆~☆~☆~
IGBTs?