This is one of the trickier build plates that i've leveled. I think that when leveling you should have the build plate over 100mm above z=0 just for extra room to mess with the screws. Also you want to unscrew the outer screws a decent amount but not so much that the bottom of the plate falls off. The outer screws control the attachment to the build plate and allow it to rise and fall. When you are at z=0 and are screwing the outer screws back in place be sure not to over tighten them as doing so will lift the build plate and cause it to lift up (creating a gap). Finger tight is good enough, you can add a 1/16th of a turn if you want to. The inner screws are for fine tuning. You can use these to adjust the pressure of the build plate if the paper is ever so slightly too loose.
Love your support and the printer!
This is one of the trickier build plates that i've leveled. I think that when leveling you should have the build plate over 100mm above z=0 just for extra room to mess with the screws. Also you want to unscrew the outer screws a decent amount but not so much that the bottom of the plate falls off.
The outer screws control the attachment to the build plate and allow it to rise and fall. When you are at z=0 and are screwing the outer screws back in place be sure not to over tighten them as doing so will lift the build plate and cause it to lift up (creating a gap). Finger tight is good enough, you can add a 1/16th of a turn if you want to.
The inner screws are for fine tuning. You can use these to adjust the pressure of the build plate if the paper is ever so slightly too loose.
huh? The inner screws are stops, they literally lock the build plate against the carrier.
At zero position the outside screws are the fine tuning screws. The inner ones lock it in place.
Wouldn't you want strips of paper underneath all 4 corners at the same time to make sure they are all the same tightness?
You can do that, I just did it myself
Hi, there. Don't worry, it can work too.
I am pulling my hair (not much left though) I followed the instruction by the letter but as soon as I tighten the oouter screws I have a gap :/
This video doesn't match the instructions included with the printer.
Which is correct?
whoa is this a new resin printer ??
Hey, there. This printer Gktwo was released in September 2022.
@@uniformation3dprinter do they have a website to view their products? I'd love to get one and review it on my channel!
086 Morar Cliffs
Instead of this stupid music, maybe some narrative and additional explanations as to why or how this works would be more useful.
Probably the most confusing leveling system out there
And the build platform has hidden chambers inside that trap resin. Needs a redesign for sure.
Nice
9093 Fadel Center
Johnson Stravenue
6066 Waylon Glens
11598 Estevan Street
621 Considine Dam
64270 Darien Prairie