How To Fit & Wire A Reverse Camera.

How to fit & wire up a reverse camera/rear view camera. This is the Seicane dual camera DVR in an MG3 but the principle is the same regardles of the car or make of camera/DVR.
link for the DVR
www.seicane.co...
Review video
• Seicane Dual Camera DV...

[@gazzafloss]

Good job Steve nice addition to your car. To find a live wire I have a "needle pointed" probe that can be fitted on the positive fly lead of my multi meter. The point will easily put a small piercing through the insulation to the copper, saves unnecessarily opening a wire if you've got the wrong one.

[@pistonbroke]

I have as well but it doesn't work. The pin wont pierce the wire.

[@richlee5578]

Watch your fingers with the blade it’s easy to slip and you were cutting towards your fingers I was cringing but otherwise good job hiding the wires was excellent

[@pistonbroke]

Blade wasn't that sharp. Probably cut better if I used a spoon.

[@tbdogfosters]

hiya what fuse would you tap in the engine bay to run an led light that will only be live when the key is turned on

[@adz63]

So the green blue is the positive? Trying to do my car atm. Not got a multimeter though. Mg3 17 plate

[@pistonbroke]

Green/brown is the feed to the reverse light.

[@adz63]

Cheers boss. I’ll continue tomorrow. Will let you know how I get on

[@davyarthurs]

I’ve had some luck with putting some tape down before drilling through. This has stopped stuff ripping. Hope u had a bit of a break away from cars 😂

[@pistonbroke]

Hindsight and all that. Oh well, done now. Had a great break, back to it tomorrow. Somehow managed to do my back in wiring up the reverse cam the other day. No doubt be in agony again tomorrow at work.

[@davyarthurs]

@@pistonbroke Glad you had a good break. Hope your bad back doesn’t hold you up too much.

[@pistonbroke]

@@davyarthurs dose up on ibuprofen, I'll survive. It's mad, pull out an engine, all fine, route some wires and can't get out of bed the following day.

[@davyarthurs]

@@pistonbroke pleased to hear that. But yep, know the feeling :-( Doesn’t add up. Best stick to ripping out engines 😝

[@kenolsen7418]

@@pistonbroke I know the feeling, just a tip to maybe avoid it in the future. Use 5 minutes a day too train the core muscles around lower back and abdomen. And it will be much more stable and hopefully you could be doing cables and pulling out engines. Best of luck from Norway.