This is not well. The extrude-cut feature is NOT available in an Inventor Frame assembly as you show. The assembly you show is not made using Frame generator, but is just some normal assembly that you cooked-up. Kindly remove this video, it will confuse matters.
This video is good but can I make holes at assembly level which then can be transferred to Frame generator Part?
Part level not transferred,
This is not well. The extrude-cut feature is NOT available in an Inventor Frame assembly as you show. The assembly you show is not made using Frame generator, but is just some normal assembly that you cooked-up. Kindly remove this video, it will confuse matters.
You're right In frame generator, pin should be used!
Check hole comment in 3D model tab