Griswold Maintenance Tip - How to Set the Impeller Clearance

John McKelvie and Wayne Plata, from Griswold Pump Company, show how to set the impellar clearance on a Griswold 811 ANSI centrifugal pump.

[@TheBadddSanta]

How come you didn't address total travel?

[@elpaso991]

Any tips for removing a stubborn (stuck) impeller from the shaft?

[@Posibrian]

heat it up

[@michaelcox3295]

Use brass and a 4lb hammer had one last night

[@PilgrimPiper]

@@Posibrian Be careful doing this as there could be a trapped vapor pocket. Peaceful days to you

[@rabahsaim8543]

Bonjour
Je voudrais faire une formation accélérée (payante ) sur les pompes pouvez vous m'orienter ?
Merci

[@Dwainpipe21]

Impeller is set 15 thousands degrees off the front of the case ???? I think you mean 15 thou of an inch! lol .How come you fit the set screws to tapped holes in the bearing frame/power end/ adaptor used when separating the pump casing if it sticks?, you can just use one of the casing screws you have removed. Nice rotating table tho that makes things easier

[@kunyit12345]

big pump.....