Размер видео: 1280 X 720853 X 480640 X 360
Показать панель управления
Автовоспроизведение
Автоповтор
Hi, can you analyze the flow of the plate heat exchanger ?
Yes. Set to constant temperature and obtain the convective heat transfer coefficient. There are a few ways.
can you explain how should be made 2 fluid solid interface because it was not explained. thanks
They should generate automatically, otherwise insert interface using insert menu.
in the end of the result, i cannot see temperature distribution. its just inside tube is in red and ZX plane in blue.. can you explain this why this happening.
Can't be completely sure. Is the case isothermal? Are there any temperature values on the legend?
i can`t also see temperature distribution because fluid solid interface was not explained or created.
@@adelgholamigholami7846 This was done automatically be the software. It groups surfaces that are adjacent and assigns contact regions.
Hi, can you analyze the flow of the plate heat exchanger ?
Yes. Set to constant temperature and obtain the convective heat transfer coefficient. There are a few ways.
can you explain how should be made 2 fluid solid interface because it was not explained. thanks
They should generate automatically, otherwise insert interface using insert menu.
in the end of the result, i cannot see temperature distribution. its just inside tube is in red and ZX plane in blue.. can you explain this why this happening.
Can't be completely sure. Is the case isothermal? Are there any temperature values on the legend?
i can`t also see temperature distribution because fluid solid interface was not explained or created.
@@adelgholamigholami7846 This was done automatically be the software. It groups surfaces that are adjacent and assigns contact regions.