PS2 Repair: Troubleshooting Common Video Issues
HTML-код
- Опубликовано: 16 окт 2024
- ps2 video troubleshooting
support the channel please
www.ebay.com/i...
that would be great
/ racervideogamesandps2a...
ebay seller
www.ebay.com/s...
400R Laser listing
www.ebay.com/i...
you are the best 🤗
It's not a problem it's a passion for electronic repair.
Change the IC that does be near the controller cable. That is the cause of no video
the toshiba IC
@Modzie868 No, that is a different ic for the controller. What board is it?
rb109 resistor ic between the ee engine and graphic chip
you have to get it of another motherboard
It's the IOP RAM
Mines show but has lines running through it
Check the network resistors they're bad between the cpu and GPU. Good luck finding them. I have to take them off donor boards.
@@axcc thank u I'll check for a donor board I guess
@axcc, can't you just use 47ohm 0603 resistors?
That is a resistor ic you can try it. I never have to i have a lot of gh-15s that are dead around
I have a ps2 that has video issue maybe i could send it to you to check out
I would be more than happy to if it is not a 30001r
@@axcc 39001
@@axcc its a 39001 i believe how can I contact you
Look on my page email is there or at axcc123@netzero.net
I would try to get someone with a better setup. This is not an insult to him but from what I see he doesn't have a bench or other proper test/soldering equipment. With smd soldering in the ps2 you need a stable surface, esd protection, microscope and a good temperature controlled solder iron where you can set the exact temperature. This is also just my opinion so take it with a grain of salt. My experience though is that when you cheap out on your equipment you get less than desirable results. For instance when using a cheaper iron the temperature will fluctuate and cause more sold solder joints.
Ps2 scph 75004 black display 😢😢😢😢
Check the network resistors between the GPU and cpu should be 47 ohms