I crashed my quad and I thought it was the tx as I just loaded er9x. I got the new arm,s that broke and after a frame rebuild I was going to erase and reinstall the firmware. When I go to terminal and click connect it starts running data on the screen and it will not end. I let it run for about 2 hours. I can calibrate the compass and the gps locks. I'm connected with usb. MP said pre arm was ok, no messages. I don't want to try it again until I got the new firm ware. I got a pic of the screen. The reset button does't do anything either. Bad board? Any ideas or suggestions. Help
please write in titel, wich version from APM you use, at version 2.6 doesnt work. everybody filled the net with unusable informations, i dont understand this
A quick and simple instruction. Thanks :-)
Hmm. Easy enough! Thanks
i have no terminal option in my mission planner
I crashed my quad and I thought it was the tx as I just loaded er9x. I got the new arm,s that broke and after a frame rebuild I was going to erase and reinstall the firmware. When I go to terminal and click connect it starts running data on the screen and it will not end. I let it run for about 2 hours. I can calibrate the compass and the gps locks. I'm connected with usb. MP said pre arm was ok, no messages. I don't want to try it again until I got the new firm ware. I got a pic of the screen. The reset button does't do anything either. Bad board? Any ideas or suggestions. Help
please write in titel, wich version from APM you use, at version 2.6 doesnt work. everybody filled the net with unusable informations, i dont understand this
Cant connect! Why?
hmm...what about 3.2 version? doesnt let you do this! :/
hotoj1 ok thanx