This is a great update. I would like to know, which motherboard you use...The GTM32 has no connector for that. Can you explain something about your work, please?
I've gone through most of your posts on thingiverse and got the new duet maestro board there, currently doing up the wiring. I was wondering how did you wire up the extruder cable? or did you just go straight to the pins and wire directly to the board?
hi i have the same 3d printer i can see that you change the motherboard, are you using a arduino mega with marlin?, You could explain how you did it? please I'm desperate I bought this printer almost 9 months ago and I can not print anything
This is a great update. I would like to know, which motherboard you use...The GTM32 has no connector for that. Can you explain something about your work, please?
I've gone through most of your posts on thingiverse and got the new duet maestro board there, currently doing up the wiring. I was wondering how did you wire up the extruder cable? or did you just go straight to the pins and wire directly to the board?
Will you be sharing how you did this ?
With all the problems this printer has and most people don't get a print out of it.
hi i have the same 3d printer i can see that you change the motherboard, are you using a arduino mega with marlin?, You could explain how you did it? please I'm desperate
I bought this printer almost 9 months ago and I can not print anything
Hey how u done. Plz reply. I have this 301 and i am bore of leveling plz rply
Hello, can do you send me the Firmware ?
How u do that
Some people just never learn how to film properly. Do it in landscape mode please!
Okay everyone, you can find information about this project on Thingiverse at www.thingiverse.com/thing:2389034
Can you share your firmware for the duet and wire diagram?