Is there a way to do more than 3 cycles? I was thinking of programming a bunch of them at slightly higher intensity each time to make a “poor mans” DVI
Very helpful but I have one question. I don’t have a control head but I’m using a Carson brand slide switch and buttons and I just hook the wires I want to it but how do I get the virtual inputs to flash on that wire
Thanks, now time to try to figure out some fancy patterns. Do you have any recommendations? I was going to program some different patterns for Wail, Yelp, and Piercer, but no clue where to start.
Hey Kent I know the ramp up pattern is coming eventually, but until then could you program one using this method? Using maybe 6 virtual inputs set 1st one to steady pattern at 10% power intensity, say 500MS for variable timer, then next input same thing but at 20% intensity and so on? and then just repeat? So it would get brighter every input when it goes to the next state?
Is the Lightbar section of the program supposed to display the patterns cycling? I have followed your directions however when I attempt to play the pattern it doesn't.
No, the lightbar section will only display the pattern that is currently displayed on the select input. You have to transfer this to your hardware to see the cycle in action.
Great lesson thank you very much but next time please play it even though the patterns were lame no offence it would have been cool to see LOL
Is there a way to do more than 3 cycles? I was thinking of programming a bunch of them at slightly higher intensity each time to make a “poor mans” DVI
Yes in theory just add more cycles and keep it going.
Very helpful but I have one question. I don’t have a control head but I’m using a Carson brand slide switch and buttons and I just hook the wires I want to it but how do I get the virtual inputs to flash on that wire
Thanks, now time to try to figure out some fancy patterns. Do you have any recommendations? I was going to program some different patterns for Wail, Yelp, and Piercer, but no clue where to start.
I personally love Ultra Scan! Add white and change the phase and it looks amazing
Hey Kent I know the ramp up pattern is coming eventually, but until then could you program one using this method? Using maybe 6 virtual inputs set 1st one to steady pattern at 10% power intensity, say 500MS for variable timer, then next input same thing but at 20% intensity and so on? and then just repeat? So it would get brighter every input when it goes to the next state?
I am only using the wires off the weCan control point . Is there a way I use this and assign it to a wire color instead of a control head
How do I program this to the slider?
Is the Lightbar section of the program supposed to display the patterns cycling? I have followed your directions however when I attempt to play the pattern it doesn't.
No, the lightbar section will only display the pattern that is currently displayed on the select input. You have to transfer this to your hardware to see the cycle in action.
@@kentclark6887 Awesome, Thanks Kent!
It’s not working at all