Can you share the information regarding General rule for 1.kiln girth gear and pinion permissible of root gap, backlash , radial run-out, axial run-out. 2. Ball mill gear and pinion permissible of root gap, backlash , radial run-out, axial run-out. 3. Kiln shell radial run-out, axial run-out. I will be very thankful for that. 🙏
I think there is a gap in the gear mesh, Gears are not 100% parallel, unless the finishing is so bad that the gears are curved?! in other words the backlash is not the same on both sides and the pressure point or the touching surfaces are not really touching on both sides (there is a gap it's not ZERO) ?!
@@GlobeTrotterJAY hi Please can you tell me...If we are getting backlash at certain position very low i.e. 0.2 to 0.4 in cold conditions of kiln in both pinion,and in hot we are getting more than 5 in this case any pinion adjustment required? Module is 45 and during static inspection we observed pittings in certain set of tooth flanks
![[Limbus Company - Teaser] Season5 - Oblivion](http://i.ytimg.com/vi/8anKuEeZLeI/mqdefault.jpg)
Can you share the information regarding General rule for
1.kiln girth gear and pinion permissible of root gap, backlash , radial run-out, axial run-out.
2. Ball mill gear and pinion permissible of root gap, backlash , radial run-out, axial run-out.
3. Kiln shell radial run-out, axial run-out.
I will be very thankful for that. 🙏
La synchronisation de denture pignon. D attaque et couronne c'est très precis
Can you please make a video about "what do you do if the root clearance is way beyond the permissible limit?". Thank you
kiri sure, I will try to cover this topic as soon as possible, thank you 😊
What reason killn girth gear out of centre in killn sheell
How can I know that if the girth gear module is 50 then what should be the the backlash clearance and root as well...?
Do you have any videos on how the floating tyres get assembled? thanks
That chair will be removed or remain as it is after the installation?
It is removed after installation; they are termed as Girth Gear alignment fixtures
I think there is a gap in the gear mesh, Gears are not 100% parallel, unless the finishing is so bad that the gears are curved?!
in other words the backlash is not the same on both sides and the pressure point or the touching surfaces are not really touching on both sides (there is a gap it's not ZERO) ?!
बहुत ही सुंदर
Root backless and girth gear alignment ke bare mein information Kijiye sir
Is this gear casted or made by other process
Sir plz tell me how to change girth gear felt
Gearth gear ka clearance ketna rakhte hai
I appreciate your efforts
Thank you very much for your appreciation, it motivates me to make more and more videos 😊
need some help about this alignment. ??
Let me know what help you need
Sir clearance kya rhta hai
Pinion to ring gear ruth gaph to breakless kitna mm rakh 8 ya 10
Kya aap Module bata sakte ho????
@@GlobeTrotterJAY hi
Please can you tell me...If we are getting backlash at certain position very low i.e. 0.2 to 0.4 in cold conditions of kiln in both pinion,and in hot we are getting more than 5 in this case any pinion adjustment required?
Module is 45 and during static inspection we observed pittings in certain set of tooth flanks
How much clearance permissible
To simplify for a spur gear it's around 25% of the module in cold condition