Vauxhall Astra H - Front Brakes Replace

In this video we show you how to replace front discs and pads on a 2008 vauxhall astra 1.9cdti.
The following tools/materials are required:-
17mm wheel nut socket
7mm allen socket
18mm socket
Ratchet
Torx 35 bit
Hammer
Flat head Screwdriver/small pry bar
Caliper wind-back tool
Torque wrench ranging from 25Nm to 110Nm
Wire brush
Brake grease
Brake cleaner
DOT 4 brake fluid
Brake pads
Brake discs
Link to Brake bleeding video:-
• How To Bleed Your Brakes
DISCLAIMER
All work should be carried out by a competent professional and torque settings should be obtained from your own source.
Don't Forget to visit our website and online store!
www.dtb-performance.com

[@warrenem4]

Fantastic video really helped me out

[@DropTheBoxOfficial]

Thanks for the feedback 👍

[@kingwolfiee3840]

Need you in my life right now 😂 need to do all 4 disc n pads on mine.

[@DropTheBoxOfficial]

It's not a bad job to do 💪

[@mark70s29]

Very professional work!

[@DropTheBoxOfficial]

Thanks for the feedback 👍

[@_3.time_]

Brilliant video mate, appreciate the editing. Very helpful 🙌👌🏴󠁧󠁢󠁷󠁬󠁳󠁿

[@DropTheBoxOfficial]

Appreciate the feedback ☺️

[@nooby123noob3]

Hi mate did you pump the breaks after you put the break reservoir cap on?

[@nooby123noob3]

Should you not pump them before you put the cap back on?
Im not trying to be rude its because I wont to know for myself , thanks

[@_3.time_]

@@nooby123noob3 well the cap holds pressure mate, so I wouldn’t unless you want brake fluid pissing all over the shop 🤣

[@staric4863]

Many thanks.
It helped me a lot.

[@DropTheBoxOfficial]

No problem thanks for the feedback 👍

[@menorthedge]

On mine astra h im bleeding the brakes done three of them but come cross front caplier right nipple wont move so ordered new front capliers, will i have to bleed all four again or can l just bleed the new caplier??

[@DropTheBoxOfficial]

Clamp the caliper brake pipe before fitting the new one, then you'll only need to bleed that caliper 👍

[@DSN262]

Replaced discs and pads on left front, cleaned slide points and put on copper grease also silicone greased slide pins. But brakes are still binding. Any idea?

[@DropTheBoxOfficial]

Make sure all your brake lines are in good condition (none have been crushed)
Possibly an issue with your caliper.

[@krzysztofk3335]

Prowadnic zacisków systemu ate się nie smaruję

[@DropTheBoxOfficial]

It's always recommended to lubricate the sliders with fresh grease

[@krzysztofk3335]

Prowadnice po których przesuwa się klocek hamulcowy to tak ale prowadnice po których przesuwa się zacisk ,prowadnice w gumowych osłonach się nie smaruję