The linkage just snaps onto the carbs. There is a ball on the carb. The linkage has a socket the ball snaps into. Often when the ball and socket get old, worn, or dry they are about impossible to remove. Use lots of WD40 or an oil can to lube the ball and socket. You might need to use a screwdriver or small pry bar. Good luck.
How do you disconnect the throttle linkage? By pulling or there is something to unscrew?
The linkage just snaps onto the carbs. There is a ball on the carb. The linkage has a socket the ball snaps into. Often when the ball and socket get old, worn, or dry they are about impossible to remove. Use lots of WD40 or an oil can to lube the ball and socket. You might need to use a screwdriver or small pry bar. Good luck.
I just made this vid. See if it helps you. ruclips.net/video/P4SUhAPAIT0/видео.html
Do you still offer this service? what do you charge?
Sorry, do not offer this service. Google Just Carburetors, Miami, FL . They can take care of you. Tell them Will sent you.
While using the air synchro meter, what’s the correct measure both carbs should have?
I see between 4-7 normally. The important thing is if you have multiple carbs, they are read the same.