you prolly dont care but if you're bored like me atm you can watch pretty much all the new series on InstaFlixxer. I've been watching with my brother for the last few months =)
it has draw key. bottom slot in the spindle is for it and tool has slotted trough hole. but with this tool i didnt use it. holds just fine with out the draw key. like drill bit if there is cutting pressure it wont drop.
Drilling is the easy part. Aligning and setting up the boom is the hard part.. 😎
you prolly dont care but if you're bored like me atm you can watch pretty much all the new series on InstaFlixxer. I've been watching with my brother for the last few months =)
@Dario Titan Definitely, been watching on InstaFlixxer for since december myself :)
How do you set up the top and bottom??
Отличные станки и работа на 5+!!!👍
Вопрос, показал бы, как межцентровое выставляешь?. И как борштанга в шпинделе зафиксирована? Я фиксировал специальной шпонкой. Но оно, не комильфо.
I was always told that a single point boring tool would pop out of a Morse taper drill. Does yours have a drawbar?
it has draw key. bottom slot in the spindle is for it and tool has slotted trough hole.
but with this tool i didnt use it. holds just fine with out the draw key.
like drill bit if there is cutting pressure it wont drop.
@@TJussilainen you dont worry about the spindle bearings?
no machine is made to do heavy drilling and this kind of work and has bigger bearings than most of mills
ive done many vertical line boring jobs on our radial drill, never had one pull out and our bar is 4 times the size of his, same size drill.
Nice litil boring bar
Лайк.
Jobs 10 sal Ka experience