Hey man, just some constructive feedback. From a visual standpoint, it's a good high resolution video. The cheesy music and all the flashy animations just take away from it though. You'd be a lot better off with just a simple narration of what you're doing. Thanks for the video in any case.
For me, they are always the same pattern, bottom left to top middle, bottom middle to top right and the lastly bottom right to top left. Never seen a 3 phase motor not configured like this.
Like it!
Could have been a good video with some verbal instructions instead of that obnoxious music.
Many thanks
When I measure coil resistance then should I select resistance mode in the megger meater?
Nice
while doing insulation resistance ,megger was set to dv voltage ?
Hey man, just some constructive feedback. From a visual standpoint, it's a good high resolution video. The cheesy music and all the flashy animations just take away from it though. You'd be a lot better off with just a simple narration of what you're doing. Thanks for the video in any case.
Agree
I think the videos better without chatting shit and boring us. Was great thanks for the video
Hey man, just some constructive feedback. Not everyone operates the same way as you do. Why not make some of your own videos?
Hey Iamzimbabwe36 eat a bag
Unable see display clearly...
So what happens when the motor is reading low resistance? Does it set off the overloads or burn the cables in the control cabinet?
It triggers short-circuit or overload protection.
So if I had zero between earth on one winding is that an earth fault and it needs rewinding
That's right.
Can I use a normal multimeter for insulation test?
No, but you can use simple multimeter to check windings continuity.
@@AboutElectricity what is cheapest meter option I can get tondo insulation test? From eBay..
@@MLK.PaNoRaMa the one from the video is Megger MIT 310. But I dont know if it is the cheapest.
Is that >1000 Mohms?
where is the megger display
When select 500 volt that time also readings shows in ohms or voltage. Please explain
When selected 500V means you are applying 500V between testing probes to do insulation resistance test.Resistance is displayed in ohms.
how to do it by a micro ohm meter ??
The same way but you can't do insulation test.
Hi jake
you didn't insulation resistance test between windings 2 and 3
Jason Ryan Mea Culpa.You're right I have forgot to megger between the windings 2 and 3.
Bruh i just had to say same comment lol
@@AboutElectricity when doing between 2 different windings shouldn't you up it to 1000v?
@@kylemailey7661 I dont know, I remember being told by someone to go double the voltage than what the motor usually runs on. Not sure if this is true?
not clear what are done on the megger adjustment
what part of the movie?
Sir only you can see the reading of your megger
how do you know which winding is which?
I checked the resistances at the ends of the windings.
For me, they are always the same pattern, bottom left to top middle, bottom middle to top right and the lastly bottom right to top left. Never seen a 3 phase motor not configured like this.
Sir video me kuch bhi thik se displays me dilkh nahi raha he
English please.
?????????
DUDE WHATS BACKGROUND INSTRUMENTAL
U should be show some value man
Hi ! Does this presentation deserve 👍 or maybe 👎 ?
😄😂
kuch bol bhi dijiye sarkar..
Megger reading is not clear
Can you turn off the dam music and speak like a person
This noise music behind the scene
Sir, It could be better if you test on actual cable.
Nooo clarity
Why no mouth talkimg?
why would anyone that looked at this like it?
horrible music. Explain what you are doing
Poor illustrations, kill the music…
Nice
Nice