Just shows that you can’t just whack on modern/upgraded parts/drivers on units and expect mind blowing results. Despite of it sounding all well and good in theory. I like the original driver better since it’s clearly made for it and the un-sang engineering principles that are at work all of the sudden goes away when you replace crucial parts/components that aren’t intended for the task(s) at hand.
Original alot clearer but upgraded one has more high, mid and low balance. Original is better overall, but the upgraded one will also work the best during cheap replacement time🙃
I drilled mine out and put in a 2.5" 9w 8 Ω driver in to replace the 3w 4 Ω 1" one that was in it.. sounds a fuk ton better because i think the chip they used for the amp circuit is actually rated for 8 Ω but they used that little scraggly wire to hook up the speaker, i replaced it with some proper oxygen free braided and shielded speaker wire... little work but free is free.. speaker came out of a cisco conferencing unit.. so is a full range plus actually has way more range than the original did..
Awesome video..The new speaker sounds almost as if it was wired in reverse polarity, I would double check the speaker wires to make sure they are not reversed and that they match the + and - polarity on the original speaker.
Doesn't matter because there is just one speaker driver in the whole system so the polarity does not matter. The new speaker just doesn't have the right parameters.
I think the old one is running on peak performance where the new one is not. It can handle more but more power isn't available to show us the performance. Maybe if he would have upgraded the amplifyer or got a speaker with higher sensitivity
Hello. One question. Is this single-driver speaker able to reproduce full stereo tracks? Recently I have sold one and was set back because customer mentions that she had one G=2 and it was able to play stereo tracks. I have tested mine listening to stereo test tracks and when playing R channel it sounds very low. Also by playing Lenny Kravitz´s "Are you gonna go my way" I can not hear the second guitar played on the song intro. Have I reveived a fake speaker? Is mine broken? I will thank any answer to this question. THanks
I don't know which speakers are good in 3w 4ohm Can U tell me? With dust cape dome like structure (full range) Or Flate concave shape silver coloured (full range) (All these in cheap Market) Which is better with Pam 8403 3w amplifier board?
@@afistfulofpimples1745 you obviously don’t have the smaller upgraded boost model, which is half the size and sounds twice as good. It should be an embarrassment the motion plus is bigger, louder, and still has less bass and doesn’t sound nearly as good as the baby brother.
Jbl sound is more cleaner and bass full than the upgrade, just trashed a nice speaker that I own my self one and don't see nothing like jbl go 2 for price until 100 dollars
The original driver is more clean and has lower bass
Nah i did same its petter than originall
The original is just working harder. If there were more watts available the new one would be better.
@@lil_no_wilii bro where do you ordered it from ?? Can I know
the classic woofer has more treble,and the aiyima woofer has more bass I think?
Where can I buy for the replacement?
Aiyima is the goog one
Just shows that you can’t just whack on modern/upgraded parts/drivers on units and expect mind blowing results.
Despite of it sounding all well and good in theory.
I like the original driver better since it’s clearly made for it and the un-sang engineering principles that are at work all of the sudden goes away when you replace crucial parts/components that aren’t intended for the task(s) at hand.
com o Auto Falante original o som ainda se saiu melhor
Vdd
Tem nem comparação
O original é mais limpo o outro só tem um pouco a mais de grave
Claro, o altifalante é tunado para a sua caixa e a maneira que o som salta la dentro, trocar o driver normalmente só piora.
No
the original driver is better/cleaner i think personally, even in a little speaker like this
The original is operating at peak watts. The new one has headroom and won't sound better until more watts
Original alot clearer but upgraded one has more high, mid and low balance.
Original is better overall, but the upgraded one will also work the best during cheap replacement time🙃
Not really, that upgrade aiyima better than originally jbl
I had an cheap Bluetooth speaker want to upgrade every but the enclosure is great from Pyle
Has more bass
But orginal plays more clean
are those new driver waterproof?
Cool upgrade👌..
I think i prefer the original one :)
Nice bro✌
isnt waterproof anymore?
It still waterproof?
Nice bro👍✌
I think i would still pick original overall
I drilled mine out and put in a 2.5" 9w 8 Ω driver in to replace the 3w 4 Ω 1" one that was in it.. sounds a fuk ton better because i think the chip they used for the amp circuit is actually rated for 8 Ω but they used that little scraggly wire to hook up the speaker, i replaced it with some proper oxygen free braided and shielded speaker wire... little work but free is free.. speaker came out of a cisco conferencing unit.. so is a full range plus actually has way more range than the original did..
Nice work man ...👌
Hey is that still working?
Superb work
bro, where can I buy online this speaker?
I am planning to replace my speaker. What's the size of it? Is it 1.5inch?
Where to buy original speaker replacement for jbl go 2?
my best guess would be any Go 2 part out listing on Ebay.
Awesome video..The new speaker sounds almost as if it was wired in reverse polarity, I would double check the speaker wires to make sure they are not reversed and that they match the + and - polarity on the original speaker.
Doesn't matter because there is just one speaker driver in the whole system so the polarity does not matter. The new speaker just doesn't have the right parameters.
:D dude u have to learn a lot...there is no difference in one speaker system.
I think the old one is running on peak performance where the new one is not. It can handle more but more power isn't available to show us the performance. Maybe if he would have upgraded the amplifyer or got a speaker with higher sensitivity
IF YALL DIDNT KNOW THE TWO SPEAKERS ARE MADE BY THE SAME BRAND
what glue did you use?
just the general silicone.
Can you please tell me what the length of that driver I want to replace mine because it's broken
these are 45mm driver i think
Original ❤
upgrade or downgrade?
Downgrade ,,,
What is the size of the speaker need to replace mine
40mm
Exactly this is not upgrade but downgrade 😄
where can we buy the original one?
Can you make one of the Sony srs-xb12 please👌👌👌
@@HBV90 thanks bro. 😁😁
Hello. One question. Is this single-driver speaker able to reproduce full stereo tracks? Recently I have sold one and was set back because customer mentions that she had one G=2 and it was able to play stereo tracks. I have tested mine listening to stereo test tracks and when playing R channel it sounds very low. Also by playing Lenny Kravitz´s "Are you gonna go my way" I can not hear the second guitar played on the song intro. Have I reveived a fake speaker? Is mine broken? I will thank any answer to this question. THanks
Whats the same of that subwoofer the oval shape next to speaker and what size
is the new driver waterproof?
I think no 😂😂. Because the membrane is made of paper and on the original JBL speaker the membrane is made of plastic
what is the exact measurement of of speaker you buy and the stock of jbl go 2 speaker
What if you add both?
Is this driver the same as jbl go 3? what diameter is it?
Original sound crystal clear
What speaker size 2.5 2.1🤔
Será que fica bom com falante de 6 polegadas pra bater baixo?
Can you send me the link of new woofer?
Original in better ❤❤
What size is this and is this available in shoppee
Fact: thats the driver the jbl 2 clone uses😂
True
No i have that speaker it has 5 watts same as the og but the fakes uses generic but looks same to dis speaker
@@AJREVIEWS2509 have you heard of the thing call joke?
@@erenmuse58 Do you know "FACT" pls read it again im just trying to correct him🤔
How to buy jbl 3watts driver
bro how many mm is the replacement
What about waterproof?
Where you buy the replacement speaker
Mi palante jbl go2 verde cuando le pongo volumen maximo se apaga solo
The vedio was cool so Can anyone help me out for ordering JBL 5watt drivers???? Where from can i order ?
you can get these from Ali
Can you make a jbl go 3 powering subwoofer 😊😊
Can you share link to ayima speakers?
Driver buying link plzzz
Both drivers sound. Kinda same but the older driver has more treble
Can1 give the name this song 3:07
“Dust caps are important.”
@@HBV90 Get an Ifixit essential toolkit dude 👁️👄👁️
Or the minnow kit.
Fun fact: The JBL Xtreme 2's newest model has the dust cap removed and it sounds much better than the older models
@@T_chOnYT the dustcaps are still there just flat
@@idk-bo6uq I guess
Donde consigo el driver?
how can you get this movement?
pleasee help meeee
Where can I buy that 5 watt driver???
Where y get the speaker from
El mio 15 Días de comprarlo se quedó mudo .se conecta pero no sale la música sera que se rompió el parlante?
Probaste reiniciar el parlante buscá vídeos en RUclips de como reiniciar el parlante hay te sale
Does it sounds better? Because I found that the speaker replacement you’re using is kinda cheap.
The old one was also cheap
Alto falante original está com timbre de mais qualidade. Som mais limpo
Bruh this man really converted a authentic jbl go2 into a fake one
Oyes que tipo de bocina le pusistes
The new driver have a better look. I hate the look of "dustcapless" inverted hyperbolic membrane transducers.
Any link to buy the replacement speaker(driver)
No
I don't know which speakers are good in 3w 4ohm
Can U tell me?
With dust cape dome like structure (full range)
Or
Flate concave shape silver coloured (full range)
(All these in cheap Market)
Which is better with Pam 8403 3w amplifier board?
EriceLs👍👍👍👍👍
Everything you can replace accept JBL factory original drivers
Bro bye the driver please link
ถ้าจะเปลี่ยนดอกต้องเป็นของปลอมเปลี่ยนแล้วสะเทือนเลยเบสแน่นเลยpassive เด้งเลย
open lfm?
Essa caixa não é uma JBL GO2 original. A construção é bem inferior e até a placa é diferente.
Put something decent in there like something from peerless
Please please please 🙏 can you do anker soundcore motion Q disassembly i would love to see that!
No
@@dwyanematthew2628 or what
ayiyma speaker ( Driver, not woofer ) have better low freq ! :+|
Driver*
There's no point replacing the driver since the amp is delivering the same amount of power
Yes you are correct. This was experimental to see how it sound with different driver.
yo we got the same job go 2
Original speaker is better.
Somebody needs to remove the passive radiator from the Anker Motion Plus and install a dedicated powered subwoofer in that space.
Ikr
No they don't
@@afistfulofpimples1745 you obviously don’t have the smaller upgraded boost model, which is half the size and sounds twice as good. It should be an embarrassment the motion plus is bigger, louder, and still has less bass and doesn’t sound nearly as good as the baby brother.
Hey can u plz open infinity fuze 99 plz bro🙏
3w RMS or 5w PMPO
5w rms
Original e muito melhor que o adaptado, ainda tem a parte da vedação do produto que n fica confiável no adaptado
The original driver is more clean
Real driver more clarity sound😢😢
The JBL speaker has more clarity.
Ну да....есть разница, одно звучит как из пластикового ведра , а другое из такого же пластикового ведра , но уже поменьше)
Speaker original more clearly
2. hoparlörün sesi boğuk geliyor
Original is the best
name end sond
For what ?!
The original speaker sounds better
Grille does not just pop out.
esse cara é maluco
is not an upgrade.. its a downgrade
I wanted to say that
Старый лучше!
What is the size of the speaker sir?
Jbl sound is more cleaner and bass full than the upgrade, just trashed a nice speaker that I own my self one and don't see nothing like jbl go 2 for price until 100 dollars
Jbl bluetooth speakers are not good, they never were.
3:50