I'm having the same prob but with one thing different I turn the key to position 2 I get the F showing on the dash car won't turn over and all lights work exsept my reverse light, turn key off and on again if the reverse light comes on car starts up but will try and cut out wile driving any ideas pal
Thanks Bro 👊 🎉have the same problem at my 1.6 opc in Germany Its also a Corsa D from 2009 with a bigger Engine 192HP - the position of the crank sensor will be the same ? I bought the original sensor from the Opel (Vauxhall) Dealer and payed 112€ 😢Hope i can fix it
Hello..do you re-learn the sensor after installing it? or do you incounter problem after using the car ?or it keep working properly without problem...thanks waiting for your answer....
Afternoon, very helpful video! I own a Vauxhall Corsa SXI 2010 1.2 petrol. The start up of the engine seems to be struggling then when eventually starts up the idle revs sits abit too low around 400rpm and feels as if it’s going to stall but doesn’t. Any ideas where to begin? Thanks
Hi Mate, The question is where is the sensor located at engine block or the gearbox case ? Whilst removing the sensor from my corsa D 1.2 it just snapped in half then trying to pry it out it fell inside the hole can't get it out at all. I'm wondering where it has dropped which side engine or gearbox side near fly wheel. Help or advice would be appreciated. Thanks
mine 1000cc 2010 3cyl is running fine but the engine light is on, and scan says Cam shaft sensor - fitted a new one (but I didnt test it) and after reset the engine light goes out but comes on again (same fault)
2007 d having can chain changed and crank sensor. Already had a replacement crank sensor 6 years ago, came to remove it, the bolt was loose and the sensor was not fully home so had been leaking oil for a long time (owner had to top up regularly). Had to use screwdrivers to lever sensor out because it was very tight, New sensor won't even go down the hole, I would have to tap it in or sand it down a bit. Are there two different types of sensor for these engines?
I don’t think there is... it quite normal to have difficulties to remove the old sensor as they swell up just clean the hole just in case there is any gunk or debris, lubricate the new sensor seal and push in sometimes it takes a little bit of force to get pass the o ring 👍👍👍👍
Hello I have opel corsa D 1.2 gpl tech my problem is cranking too long before it starts..I use obd2 scanner but nothing light code...please help.thanks from Italy
Hi there, can anyone tell me why i can't turn off my spanner light on a vauxhall corsa 2010 1.3 diesel, the service as been done, i tried to reset the light, but it would go out, so i've put it on a diagnostics machine, it's telling me there are no faults with the car, car starts and drives fine. Thanks.
I have corsa 2010 reg 1.3 diesel it’s starts up after few minutes cuts out I’m struggling I don’t know what’s the problem is, -We change fuel pump Could you help please Thanks
Cars Exposed The local garage man says fuel rail pressure sensor we change it that bit as well still same problem. The car is starts fine after few minutes drive up it’s cuts out itself Thanks
Let’s start from the basics, when was the last time you have changed your diesel filter? Would be a good idea to hook up a pressure gauge at rail to know what sort of pressure there is when the car stalls, and perhaps do an injector leak back test ...
It could be but it would most likely trigger a code for it, needs testing ... if you have a code for lower pressure in the rail i would test everything around first....
That's right Scott it was a shame that i couldn't show it in the video because the car didn't want to start but it was on when my friend dropped the car off 👍
eduardo estrella remove the e10 bolt than pull the sensor out , sometimes it can be a bit stuck so try to twist and pull action eventually it should come out
Nice and straight job... in and out....
Well done!
LM Auto Repairs easy peasy lemon squeezy I got lucky again... 👍 how’s everything bloody hot here in the south 😳🍻😀
Cars Exposed
Same here!
Which is better that rain...😋
Hi....greeting from Alex here(va tuning)....thanks to Luis i found you.Love your videos.....real live diagnosis.....
VA Tuning cheers mate I appreciate it 👍👍👍
Well done!
If I may ask, was the spark from coil pack?
Thank you buddy! Woulda never found that if not for this video
Sean Laverty thanks mate I really appreciate, I’m glad the video helps 👍👍👍
Thank you. Such a very relevant and helpful demonstration. Good job! 👍🏽👍🏽👍🏽
I'm having the same prob but with one thing different I turn the key to position 2 I get the F showing on the dash car won't turn over and all lights work exsept my reverse light, turn key off and on again if the reverse light comes on car starts up but will try and cut out wile driving any ideas pal
Thanks Bro 👊 🎉have the same problem at my 1.6 opc in Germany
Its also a Corsa D from 2009 with a bigger Engine 192HP - the position of the crank sensor will be the same ? I bought the original sensor from the Opel (Vauxhall) Dealer and payed 112€ 😢Hope i can fix it
Hello..do you re-learn the sensor after installing it? or do you incounter problem after using the car ?or it keep working properly without problem...thanks waiting for your answer....
No need to re-learn , just change the sensor and its fine
Afternoon, very helpful video! I own a Vauxhall Corsa SXI 2010 1.2 petrol. The start up of the engine seems to be struggling then when eventually starts up the idle revs sits abit too low around 400rpm and feels as if it’s going to stall but doesn’t. Any ideas where to begin? Thanks
dan walters I would start looking at some live data specially, air mass flow sensor or vacuum leaks ...
I’m having the same problem with my corsa ! I need help on it ASAP ! How much is it to fix it ?
Hi the sensor from Vauxhall cost £78, to fit it should be another 30min labour ... where are you ?
Cars Exposed you got a email or social media or whatever to contact you
Nm 25 carsexposed@yahoo.com
Hi Mate,
The question is where is the sensor located at engine block or the gearbox case ?
Whilst removing the sensor from my corsa D 1.2 it just snapped in half then trying to pry it out it fell inside the hole can't get it out at all.
I'm wondering where it has dropped which side engine or gearbox side near fly wheel.
Help or advice would be appreciated. Thanks
Unfortunately Located Engine block side , I guess the broken sensor will be in the oil sump now
Will I need to jack car for this? Got 2009 sxi model so body sits abit lower than usual with body kit, cheers.
100% mate
mine 1000cc 2010 3cyl is running fine but the engine light is on, and scan says Cam shaft sensor - fitted a new one (but I didnt test it) and after reset the engine light goes out but comes on again (same fault)
They never put the important sensors in an easy-to-remove location! =(
Thomas EXOVCDS indeed, it was one of those jobs that you spend 80% of the time removing one bolt 😳👍
2007 d having can chain changed and crank sensor.
Already had a replacement crank sensor 6 years ago, came to remove it, the bolt was loose and the sensor was not fully home so had been leaking oil for a long time (owner had to top up regularly).
Had to use screwdrivers to lever sensor out because it was very tight,
New sensor won't even go down the hole, I would have to tap it in or sand it down a bit.
Are there two different types of sensor for these engines?
I don’t think there is... it quite normal to have difficulties to remove the old sensor as they swell up just clean the hole just in case there is any gunk or debris, lubricate the new sensor seal and push in sometimes it takes a little bit of force to get pass the o ring 👍👍👍👍
I ended up gently sanding the new sensor until it passed though the hole properly
Hello I have opel corsa D 1.2 gpl tech my problem is cranking too long before it starts..I use obd2 scanner but nothing light code...please help.thanks from Italy
Superb job sir.well done.
thanks mate 👍👍👍👍👍
New subcriber like the chime if the corsa D
Is this the 1.4i Corsa. Or 1.2. Thanks
I believe is 1.2
How to get the program (detector errors) ? i like it
Hello bud, I’m using a Delphi ds150e... here is a link if you are interested 👍 amzn.to/2SS7SYI
What scanner do you use?
I’ve used a Delphi DS150
Hello how to remove the harness....I'd try but it stuck in
You have a tab to push in than pull the connector , easier to keep the sensor in place before removing the plug
Hi there, can anyone tell me why i can't turn off my spanner light on a vauxhall corsa 2010 1.3 diesel, the service as been done, i tried to reset the light, but it would go out, so i've put it on a diagnostics machine, it's telling me there are no faults with the car, car starts and drives fine. Thanks.
southsideboxing you probably need a more capable scan tool ...
@@CarsExposed @Cars, Thanks so much for getting back to me mate, what kind would i be looking for.
I have corsa 2010 reg 1.3 diesel it’s starts up after few minutes cuts out I’m struggling I don’t know what’s the problem is,
-We change fuel pump
Could you help please
Thanks
Yunus Can Have you tried to scan the car yet?
Cars Exposed
The local garage man says fuel rail pressure sensor we change it that bit as well still same problem.
The car is starts fine after few minutes drive up it’s cuts out itself
Thanks
Let’s start from the basics, when was the last time you have changed your diesel filter? Would be a good idea to hook up a pressure gauge at rail to know what sort of pressure there is when the car stalls, and perhaps do an injector leak back test ...
Cars Exposed
I have changed one week ago fuel filter?
Do you think problems will be maf sensor or crank shaft sensor?
It could be but it would most likely trigger a code for it, needs testing ... if you have a code for lower pressure in the rail i would test everything around first....
my corsa was dead ,i changed battery and after 2 days dead again (no electric power) can someone help me with a opinion?
Was the car sitting for 2 day? If it was you have a parasitic draw .
Spanner light wont go off till engine started and it stays on with ignition anyways
That's right Scott it was a shame that i couldn't show it in the video because the car didn't want to start but it was on when my friend dropped the car off 👍
Plz help me i have p0016 in opel corsa d
Have you check the live data ? What figures did you get?
@@CarsExposed p0016
@@CarsExposed correlation position de velibre-quin
Did you check the live data for engine speed?
@@CarsExposed Yes, brother
How much do you expect a mechanic to charge for changing the sensor excluding parts charge
persianbulldog in terms of changing the sensor only I would expect to get charged 30min labour
Can you show how to remove the sensor?
eduardo estrella remove the e10 bolt than pull the sensor out , sometimes it can be a bit stuck so try to twist and pull action eventually it should come out
👍👍👍
Now £5 on ebay.. 💪🏻💪🏻
Oh man result , I think I could get a new sensor from EBay for about £13 at the time ... but personally I like to get OEM sensors when I can ...👍
God jab
Thanks mate 👍👍👍👍
Po171