Yaskawa SGMG Servo Motor Repair and Test by industrypart.com Ltd

[@abdusaidabduraufov5615]

The workplace is very convenient and the work process has a high level of accuracy and control

[@elmnaoirfer3751]

Hello, how do I know the engine speed, and the position as well, do you have some equations, thanks a lot

[@estebangenaizir9191]

very well done

[@enriquealonso6316]

I got some questions of these process, It was only maintenance? Did they change the bearings? I saw two measurements, what scales of ohms did they use using the testers?

[@kmcwhq]

Shouldn't the rotor be placed in a sleeve upon disassembly to prevent magnet loss?

[@achrafbara8025]

hi mr thank you for all informations, please can you show us how we can command a servopack sigma 2 SGDM 20ADA with a PLC (for example S7 300,400 or 1200 SIEMENS) and a type of signale that we should send from PLC to servopack thank you very much

[@andymartin86]

Can you test the encoder on an SGMGH with 17bit serial absolute encoder? I notice the TI5000EX does not yet support this one.....or can you get away with reading an angle from the a b z lines and aligning it this way?

[@fanuccnccontrollerpartsson5578]

This chocho from Shanghai China Do you need yaskawa motor testing video?

[@nikhiljambhale1533]

you can not check yaskawa encoder in ti 5000

[@Saidun.ee1]

@@fanuccnccontrollerpartsson5578
Dear sir how to test encoder alignment

[@manaiahmed1559]

I have a problem in the servomotor model sgmgh-13dca6f-oy (it does not rotate
it Write error in the display table machine)

[@juanmanuelsaarenteria4053]

Donde lo envío

[@oliver0218]

May I know what is the purpose of the blue mark of the bearing when the bearing was heated?
thank you.

[@The_Unobtainium]

this is temperature marker to indicate proper bearng temperature. These are used widely in industry.

[@vinnatv4150]

Good

[@kristiantato888]

for these motors are used?