Corian Table Fabrication - Cutting a Bullnose on CNC
HTML-код
- Опубликовано: 16 сен 2024
- Reintroducing a table on CNC to cut the edge profile. A purpose-built spoiler board was made to vacuum down the Corian solid surface table. This allows the full round bullnose, profile bit to pass all the way around the perimeter of the table. This makes sanding the edge bullnose much easier because the cut and speed are consistent.
Nice one
Thank You.
Awesome! What was your design for the spoil board?
It's the same shape as the part but a little smaller. Plus it has a 1/2" gasket rope around the perimeter for a.perfect seal.
@@AndyGraves very neat! Thanks for the knowledge share
You're welcome
We’re thinking about getting a cnc for solid surface. Which cnc router is this?
That's a Multicam
what software do you run on the cnc
AlphaCAM
@@AndyGraves can you show how you used alphacam to do edge profilling.
@@Z-add We don't do it very often but the next time we do I'll film it.