been wondering how to put new cover gaskets cuz the mechanic shop wants like $350 just for the gaskets NOT including changing the spark plug or wire's ..i think if i watch the video a couple more times I'll be able to do it my self..thx for the video bro appreciate it.👍
Regards! I have a kia sorento 2003 3.5 since I changed the charcoal canister I started to 1- feel a strong odor smell of vapors and 2- the fuel consumption has increased considerably 3- when the air conditioner starts to shake. I have tried to correct the problem by changing the purge valve, selenoid valve, replaced some old lines, vent valve (inside of fuel tank), fuel pump and filter, pcv valve. The last thing I did was to clean the canister converter that is under the driver's seat and it does not tremble so much anymore. I do not know much about mechanics but I dare to do some things. Thanks for your videos!!! Gracias!!!
If you are going to put a new set of wires in then just cut the boots and pull them free. If you really want one then get a plug wire holder kit for the new ones and fish them through one at a time. easy peasy.
hi eric...great videos !!! i just did t/b and w/p and lived through it. next v/c and wires,but i think my rear cam seal is leaking. do you know anything about replacing them.i have not been able to find any info.thanks for your time...john.
Eric can you show where the fuel pressure regulator line runs to. I took Everything apart and now can not figure out where the fuel pressure regulator line connects too
So are you able to change the plugs without removing the intake plenum? I got a misfire on #6 and I'm going to change the wires and plugs and don't want to take the plenum off again lol.
Not you dont need to remove the intake plenum, you do need to remove the throttle body and if you want better access you will need to remove the wiper motor assembly
@@ERICSDIYGARAGE awesome bro and thanks for the reply. I figured it out and the problem is fix and I have to say your vid saved me so much time. Thanks again bro, you da man lol.
I'm still unsure of where the wire goes. It goes from the coil pack to where exactly at the back of the engine? Sorry if that doesn't make any sense. My knowledge on cars is very little.
My 04 optima engine is stalling while accelerating from a stop and is also cutting out while running idle. I’ve already changed the spark plugs but not the wire.
ERICSDIYGARAGE I did, and the miss fire Stay in the same 1/4 if I disconnect #1, coil 4 start throwing sparks around the cable connector, The cables look fairly good but you never now, what will be a good brand except the dealer I think they want $300 for them.
This is nuts. You have to pull half the fucking engine apart to change the spark plugs. I wish I'd seen this before I brought one of these pieces of shit.
Great video !🔧🔧
+luz vega 😉
Hey when you had a misfire did the engine light blink and was there a gentle shaking of the engine?
Everybody needs a mechanic friend like this guy!!
thank you!
Thank you so much man me and my dad has been kicking ourselves trying to figure out how to remove them for two days now
been wondering how to put new cover gaskets cuz the mechanic shop wants like $350 just for the gaskets NOT including changing the spark plug or wire's ..i think if i watch the video a couple more times I'll be able to do it my self..thx for the video bro appreciate it.👍
+Eliseo Cuevas thank you i appreciate it, hopefully your successful 👍
i have a video showing you how to replace the valve cover gaskets hope it helps .
Pay them it sucks ass to do it your self
THANKS ERIC YOUR VIDEO IS A VERY BIG HELP,I DIDNT KNOW MUCH ABOUT THE SORENTO,NOW I DO.THANKS AGAIN BRO.
thank you for watching, im glad my video helped you out👍
Wow! Impressive! Now I know how to change my spark plugs. Thanks Erick 👍
thank you !
Regards! I have a kia sorento 2003 3.5 since I changed the charcoal canister I started to 1- feel a strong odor smell of vapors and 2- the fuel consumption has increased considerably 3- when the air conditioner starts to shake. I have tried to correct the problem by changing the purge valve, selenoid valve, replaced some old lines, vent valve (inside of fuel tank), fuel pump and filter, pcv valve. The last thing I did was to clean the canister converter that is under the driver's seat and it does not tremble so much anymore. I do not know much about mechanics but I dare to do some things. Thanks for your videos!!! Gracias!!!
Great videos. You explain everything very clearly.
great job on your demo on the kia sorento very ethereal explanation keep up the good work. Art C
Thanks Erick for the video very clear and well described amazing and excellent, you just save me a lot of money too, regards.
Jose L. Dominguez thank you I appreciate it!
Thanks for filming this! I'm doing this exact job today on my wife's Sorento.
thank you for watching, I hope my video helps you out
This is such an awesome video!
Great video and interesting to watch through! Thank you
thank you for watching👍
Excellent video, I learned a lot, I got a question, where did you get the diagrams?
thank you! & I just Googled them lol
hey dude if you're still looking I get a lot of diagrams from kiapartsnow.com, I never buy parts from there though, they're all OEM and cost a lot.
If you are going to put a new set of wires in then just cut the boots and pull them free. If you really want one then get a plug wire holder kit for the new ones and fish them through one at a time. easy peasy.
I replaced both plugs and wires without removing the intake. I cut the old ones out and ran the new wires around the back.
thank you for sharing your experience
Good idea. I'll do this.
hi eric...great videos !!! i just did t/b and w/p and lived through it. next v/c and wires,but i think my rear cam seal is leaking. do you know anything about replacing them.i have not been able to find any info.thanks for your time...john.
thank you for watching! unfortunately I dont have that information
Looking at that task and wondering if they could have possibly made it more difficult and labor intensive? Shite
Eric can you show where the fuel pressure regulator line runs to. I took Everything apart and now can not figure out where the fuel pressure regulator line connects too
the regulator is in the back towards the driver side behind the intake plenum
Great video! How much would you personally charge for this job?
I would say around $200 would be fair
How long does it take to replace just the wires if plugs have already been done?
So there is only 3 coils for 6 plugs? And the 3 plugs on the passenger side have lines that run to the coils on the driver side?
it has 3 coil packs that send signal to the other 3 wire plug on the passenger side.
So are you able to change the plugs without removing the intake plenum?
I got a misfire on #6 and I'm going to change the wires and plugs and don't want to take the plenum off again lol.
Not you dont need to remove the intake plenum, you do need to remove the throttle body and if you want better access you will need to remove the wiper motor assembly
@@ERICSDIYGARAGE awesome bro and thanks for the reply.
I figured it out and the problem is fix and I have to say your vid saved me so much time.
Thanks again bro, you da man lol.
Glad It helped you out! Thank you for watching!
6Cylinder ? Looking for number 4 cyl
I wondered what they connected to as i may do vc gaskets and suggested to the lady she do plugs and wires at that time.
I'm still unsure of where the wire goes. It goes from the coil pack to where exactly at the back of the engine?
Sorry if that doesn't make any sense. My knowledge on cars is very little.
What about the wires with the black clip that's near the firewall that holds the wires??
Awesome thanks God Bless!!
Very helpful
thank you!
My 04 optima engine is stalling while accelerating from a stop and is also cutting out while running idle. I’ve already changed the spark plugs but not the wire.
How many coil packs are there ?
3 coil packs and 3 wires
@@ERICSDIYGARAGE okay thanks so with it only being 3 and 3 there aint 6 spark plugs or how is it actually set up
And another thing my car will crank but wont fire what could be the issue iv put a obd on it i got codes of miss fire and low fuel pressure
@@johnmiller623 it's a V6 so it has 6 spark plugs. The vehicle has a coil pack wire design so uses of 3 packs to send signal to the spark plug wires
@@johnmiller623 these Kia sorento's have become an issue with a crankshaft sensor
thx i appreciate it.
Ay homie why don’t you edit out the part where you trying to separate the boot from the wires? That shit is fucked up lol
Just bought the car trying to learn everything about it I've never had anything past 2000
I have to change out my coil pack getting a miss fire on 1/4
Orlando Rodriquez I have the same problem!
Did you fix it?
you might need a new coil pack move the coil packs around and see if the problem follows
ERICSDIYGARAGE I did, and the miss fire Stay in the same 1/4 if I disconnect #1, coil 4 start throwing sparks around the cable connector,
The cables look fairly good but you never now, what will be a good brand except the dealer I think they want $300 for them.
Need help guys Is it the same with the 2007 sorentos
It should be similar but your engine might be sideways
@@ERICSDIYGARAGE it's rear wheel thanks Eric preciate it
Yes its 4x4 also
What is the gap
No
I just cut the old ones and zip tied the new ones it is way to crammed to fiddle with
Why didn't you run the engine after you were done so we could take a listen?
I didn't see a reason to turn on the vehicle.
Video stops at 5 secs and doesn't move from there. The same happens on 4 different phones. FYI.
Thank you for letting me know this I will go ahead and look into it
@@ERICSDIYGARAGE Please, I need to know the order of the spark plug wires lol. Can you tell me from here?
try to look at the video now, if it does not work let me know and I look it up for you.
@@ERICSDIYGARAGE now it gets stuck at 15 secs.
This is nuts. You have to pull half the fucking engine apart to change the spark plugs. I wish I'd seen this before I brought one of these pieces of shit.
If you just need the spark plugs you can just remove the throttle body and you'll be able to swap them out.
D'ordre d'allumage