I have a lot of experience with AB PLCs, but not automation direct. To do a simple program like one shot to a add instruction and one shot to a sub instruction. For example: ons B13.1 sub N7.1 1 n7.2 Ons B13.2 add N7.3 1 N7.2 GEQ N7.2 0 OTE B13.3 I made this up on the spot for ab. You’ll copy it into the ascii bar and it will pop up. I don’t know how to do that in automation direct.
Hi Eric, The productivity series of controllers will use an edge contact. This is the same as the AB one-shot. accautomation.ca/productivity-1000-series-plc-contact-and-coil-instructions/ This post will discuss these contacts. All math instructions are done using the Math Instruction in the productivity. accautomation.ca/productivity-1000-series-plc-math-instructions/ Here is the entire series for productivity. accautomation.ca/series/productivity-1000-plc/ I hope this helps you out. Regards, Garry
Productivity Suite Programming Software v3.3.0.17 has been released.
support.automationdirect.com/products/p3000.html
Regards,
Garry
All automation direct software can be found at the following URL:
www.automationdirect.com/support/software-downloads
Regards,
Garry
I have a lot of experience with AB PLCs, but not automation direct. To do a simple program like one shot to a add instruction and one shot to a sub instruction. For example: ons B13.1 sub N7.1 1 n7.2
Ons B13.2 add N7.3 1 N7.2
GEQ N7.2 0 OTE B13.3
I made this up on the spot for ab. You’ll copy it into the ascii bar and it will pop up. I don’t know how to do that in automation direct.
Hi Eric,
The productivity series of controllers will use an edge contact. This is the same as the AB one-shot.
accautomation.ca/productivity-1000-series-plc-contact-and-coil-instructions/
This post will discuss these contacts.
All math instructions are done using the Math Instruction in the productivity.
accautomation.ca/productivity-1000-series-plc-math-instructions/
Here is the entire series for productivity.
accautomation.ca/series/productivity-1000-plc/
I hope this helps you out.
Regards,
Garry