Float Tube Mod! (DIY STYLE!)
HTML-код
- Опубликовано: 16 окт 2024
- First float tube mod complete! I wanted to ditch the mesh apron and replace it with a flat hard surface for working on fish and fishing gear! DIY cause that is the fun part!
Hardware store parts: 1- 1-1/4”x60” PVC tubing
1- PVC coupling 1-1/4”x1-1/4”
2- 1-1/4” conduit clamps
4- 5/16x3/4 stainless steel bolts
4- 5/16 stainless steel lock nuts
Boot tray: www.homedepot....
Gruv Launch Pad: www.gruvfishing.com
Powerbox: www.iceholepower.com
Can't wait to see how and where you mount the electronics!
THAT was pretty funny man .. great job!
I’m soon 75 but I really wanna go float tubing. Great video.
I highly encourage you to try it out!! Message me if you have any questions. I would be happy to help.
Its going places now!
The build road is wide open!
@@LoneAngler218 Hammer down
How has your float tube tray worked out? Is there anything you would modify or something you may have done to improve it? Did the plastic hold up in hot sunlight? Thanks....very cool modification. I'll copy it soon as I find all the parts.
Howdy! The tray has held up very well! I'm just starting my mod journey so...rod holders are next. I am going to add clips in the rear corners so I can clip it to my inside d-rings. Thank for watching and tight lines.
In the words of the fat guy in Mr Deeds “ Genius Genius Geeniuuus
How many yards is that spool of trilene in the back?
what do you think about getting the smallest drill bit you have and just making drain hole in the tray. even drill the corner of the lip. so when you tilt it, it drains everything.
Whats up buddy? Just followed your podcast. Sounds fun
Im in San Diego. Do you fish out here at all. I have a Fishcat Max 5. I float tube all around San Diego. Hitting the legendary Lake Barrett this week
Hey David! Thanks for following the podcast! I have never fished in CA but, would love to sometime. I have a brother in Vista so, the possibility is there! Happy kicking man!
That was tough
What are those black pockets on the float tube that you inserted the pvc pipe into?
Those hold the spreader pole end so the tube stays nice and wide. Those come on the tube from the manufacturer.
Now you need a tape measure sticker to measure fish.
I have a Ketch USA 16" board now! Thanks for watching!
Is that the same pvc that came with the float tube?
No sir. 1-1/4" PVC
This may be a dumb question, but why did you need the coupler?
I wanted to make to cross bar two piece so that I can pull it apart for storage. Good question!
@@LoneAngler218 Thanks!