Hi interested to install the reverse camera, after installing the camera in the rear etc, Where do i connect the rest of the wires and when selecting reverse gear how will the camera activate? Thx u
So let me get this straight, the installation is as easy as doing what you did just then, but in regards to the little red wires I would, (camera end) connect both red wires together. Feed wires to head unit (canbus included within head unit) connect red wire to 12v- on head unit. Canbus should automatically active camera on selecting reverse?
Wouldn't advise messing with the loom that runs into car as they are very tempremental as prone to breaks in wires at crease of boot closing and if disturbed you may find things not workimg,such as lights and electronics of boot but otherwise decent tutorial 👍👍👍
Il est de loin préférable d’utiliser un relais sur le circuit de la lampe de recul, puis une alimentation en direct de la boîte à fusibles via le relais, de sorte que l’alimentation de l’inverseur soit indépendante et ne génère pas d’interférences provenant du système de bus des voitures. Déclippez également le pare-chocs avant de percer pour vous assurer que vos capteurs ne se heurtent pas à l'arrière.
Does your camera goes on when you reverse? Did you use a relay? Why didn't you connect it to the rear fuse box ? I am asking this as I have a zafira B 2011 and did exactly the same as you with my rear camera (exactly the same camera you got) but it only works a few minutes and then it switch off completely taking my reverse light with it! I have checked with an auto electrician and he didn't know the reason or how to fix it.
You should not wire directly to your rear light. Your car thinks that voltage is low and cutting it. You should visit your local electrician. Or if you have Op-Com you can switch it back on.
car audio solutions thank you. I have tried fitting a relay but with no luck. If you can add a video/ picture of how you connect it I would be greatfull. I checked with my local garage and electricians they fitted my double din but said they wouldn't touch cameras.
so where did you wire it to as I have wired mine to reverse light and works fine with engine off but soon as you turn engine on it will flickers they say because of the canbus, please help
Why on earth would you need to fit a camera to a car that has enough windows and mirrors that you can just look out of. In a van I would agree as you have limited view. If that was the case why not go ahead and fit one to the front bumper as the owner of the car clearly cannot drive without its assistance. Some people ehh!!!
Hi, you can do install the cable without cutting the rubber with a Fish tape and silicone spray.
Nice one for not showing red reverse light wire connection.
gary donald
Red wire connection u can connect behind the stereo DVD player
Hi interested to install the reverse camera, after installing the camera in the rear etc, Where do i connect the rest of the wires and when selecting reverse gear how will the camera activate?
Thx u
So let me get this straight, the installation is as easy as doing what you did just then, but in regards to the little red wires I would, (camera end) connect both red wires together. Feed wires to head unit (canbus included within head unit) connect red wire to 12v- on head unit.
Canbus should automatically active camera on selecting reverse?
👍
Wouldn't advise messing with the loom that runs into car as they are very tempremental as prone to breaks in wires at crease of boot closing and if disturbed you may find things not workimg,such as lights and electronics of boot but otherwise decent tutorial 👍👍👍
i luv your vidsss plz make morexxxx
Hi thanks for the tutorial, can I ask what camera kit you used please?
Misses vital part connecting to the head unit
Absolute cowboy cutting the rubber seal, leave the wire tape it up refer to my many videos.
Sick that’s so interesting
Barbaric method. Drilling hole, cutting rubber. The last thing is to drill a holes in your car and cutting rubber isolation
Yep. It would take him like 2 minutes to pop out that rubber and pul the cables throuh it.
Music get rid
Il est de loin préférable d’utiliser un relais sur le circuit de la lampe de recul, puis une alimentation en direct de la boîte à fusibles via le relais, de sorte que l’alimentation de l’inverseur soit indépendante et ne génère pas d’interférences provenant du système de bus des voitures. Déclippez également le pare-chocs avant de percer pour vous assurer que vos capteurs ne se heurtent pas à l'arrière.
nice video but you didn't show yellow wire ( video wire ) where did you connect?
akam shalaw back off stereo with yellow pin
Does your camera goes on when you reverse? Did you use a relay? Why didn't you connect it to the rear fuse box ? I am asking this as I have a zafira B 2011 and did exactly the same as you with my rear camera (exactly the same camera you got) but it only works a few minutes and then it switch off completely taking my reverse light with it! I have checked with an auto electrician and he didn't know the reason or how to fix it.
You should not wire directly to your rear light. Your car thinks that voltage is low and cutting it. You should visit your local electrician. Or if you have Op-Com you can switch it back on.
noo one You need a relay I've done many zafiras.
Egor Tolochko thank you . I have just seen your message. What is op-com? Regards
car audio solutions thank you. I have tried fitting a relay but with no luck. If you can add a video/ picture of how you connect it I would be greatfull. I checked with my local garage and electricians they fitted my double din but said they wouldn't touch cameras.
noo one Can you come to me in Birmingham? 07967825825
so where did you wire it to as I have wired mine to reverse light and works fine with engine off but soon as you turn engine on it will flickers they say because of the canbus, please help
Greg Hill I'm wondering the best way to connect to reverse lamp too... he doesn't show us this bit!
@@bilbowilberforce5721 I heard you can get a canbus box that will stop this, it's such a let down
You need a relay 4 pole >1A, +12 from rear fuse box. Reverse wire will switch permanent +12
Amigo como haz puesto esa cámara de reversa
???? You didn't show the part where you came in the fuse box, fused it and grounded it to earth.....or did you???
ZerokillerOppel1
Connect with stereo red with red black with black simple back off DVD player wiring loom thanks
Reverse camera red wire where to connect too back lights reverse?
mak frn red wire connect back off the stereo
1:54 Look at the hair on that hand, thats not right :/
Steve Macdonald that’s a real man‘s hand!
@@Spartacus70BC lol I must still be a boy then haha
Leave him alone
@@Spartacus70BC Mmmm a real man hey 😉
Why on earth would you need to fit a camera to a car that has enough windows and mirrors that you can just look out of. In a van I would agree as you have limited view. If that was the case why not go ahead and fit one to the front bumper as the owner of the car clearly cannot drive without its assistance. Some people ehh!!!
jealous you haven't got one...