With a pull-up resistor, the input pin will read a high state when the button is not pressed. In other words, a small amount of current is flowing between VCC and the input pin (not to ground), thus the input pin reads close to VCC. When the button is pressed, it connects the input pin directly to ground. The current flows through the resistor to ground, thus the input pin reads a low state. Keep in mind, if the resistor wasn’t there, your button would connect VCC to ground, which is very bad and is also known as a short.
Can I add your contact number please, I would like to see photos of solar tacker's realistic connection method. Because I want to reproduce a similar solar tracker but I don’t know how to connect those wires in reality.
thank you
Which servo is to be connected in which pin, like vertical servo in which pin and same for horizontal??
Horizontal servo connect pin 9
Vertical Servo connect pin 10
what is the use of solar panel here and can you please tell what is the positioning of ldrs i can't understand what topleft and top right mean
Detail is given in discription
Three mortar drive, 3 rd one is flower , how to make ?.
Not understand
Can I use a nano board?
Servo motor
Yes Arduino nano
thank you
@@eazytronic9394
how can i get all the codes
Code link also given in description
@@eazytronic9394 THANKS
@@yarenberber2246 Welcome
i have some question pleasevcan you help me
Okk
it will be run on arduino uno?
Yes it work
why are you using 10k ohm resistor on ldr, can you explain
With a pull-up resistor, the input pin will read a high state when the button is not pressed. In other words, a small amount of current is flowing between VCC and the input pin (not to ground), thus the input pin reads close to VCC. When the button is pressed, it connects the input pin directly to ground. The current flows through the resistor to ground, thus the input pin reads a low state. Keep in mind, if the resistor wasn’t there, your button would connect VCC to ground, which is very bad and is also known as a short.
It will be run on esp32 ?
Yes
If it's for solar panels, where does it connect? because I did this project...
Solar cell connect with battery
@@eazytronic9394 so for the power supply what do you use?
Can I add your contact number please, I would like to see photos of solar tacker's realistic connection method. Because I want to reproduce a similar solar tracker but I don’t know how to connect those wires in reality.
WhatsApp+917007651787
@@eazytronic9394good sir