It is always good to know where to look when getting fault codes on your motorcycle. So thanks for this useful information. My FZ6 S2 is built in 2008 with 27,000 Km on the odometer and bought it from the first owner. I use the bike every day to drive to work and to tour in my spare time. Have a nice day and drive safe.
When installing additional electrical appliances like heated grips or phone charger i always use a 12V relay, that just cuts the power off when the ignition is turned off. You would get them for 3 Euros on ebay. They prevent your battery from being drained.
The FZ6 Engine Control Unit loves to throw out spurious fault codes when the battery gets low and has been the result of more Crankshaft Position Sensors being checked (fault code 12) or even replaced unnecessarily than anything else! If you can, get an Optimate or other battery tender which will greatly help keep the battery in good condition, although even that will have difficulties with a battery that's over about 5 years old. It's a good idea to use a multimeter to check the output of your Regulator/ Rectifier and Alternator because if either of those is faulty they can kill a good battery by giving too little (or too much) power. Also you can buy a Drop Tester from eBay or similar for around £20 which is a good way of seeing if the battery has dropped a cell and letting you know if it needs replacing. Finally don't forget that a brand new battery can be duff as I found when I replaced one and then still had problems starting! PS You can clear the old fault codes by using setting 62 in Diagnostic Mode.
Awesome thanks very much. I’ll definitely be getting some tools to test the charging system in the ways you described. I feel it was too easy of a fix on this occasion... worth double checking. Thanks for the comments and advice 👍
Love/loved my fz6 S2. Done 53k on it now and the last 6 months I have had nothing but electrical issues from stator, rectifier, fuel pump, immobilizer and coil packs.... Mechanically brilliant suspension and brakes are perfect just got he age where wires get a bit mardy...... Good video tho keep going.
I feel the same way about the bike. Absolutely love it. But it is entirely possible that it’s just getting to that age where wiring/electrics could start becoming and issue. Thanks very much, glad you enjoyed the video. I plan to do some more electrical tests once I have the tools fo it 👍👍
@@FabMotorbikes I managed to find an ECU and wiring harness to replace my aging one (ECU pins actually got corroded by water ingress) I'm sure it's going to be fine again once replaced but she's going up for sale as I brought a new steed already :)
@@FabMotorbikes a Kawasaki z750r.... Nothing mega fancy bit just loved the way it looked then I had a ride ... It's so smooth instantly fell in love ha bikes do weird things to your emotions ha
Yea I understand. Sometimes I turn down offers to ride other bike because it has lead me to going an getting one myself whe I have a perfectly good bike already 😂😂 I’ve always liked the z750. I don’t know much about the ‘R’ version. I assume it has a bit more aggressive/racing characteristics.
I have same the exact same bike. Had a new battery put in 6 months ago, left the bike outside untouched for a month and voltage dropped to about 10v (from the dash diagnostic), tested with a voltmeter and it’s about 11v. Anyway I whipped it out, plugged in on a trickle charger for about 6 hours, now it’s back up to 13v. Let’s hope it stays that way!
Good luck! Hope all runs well 👍. I ended up doing some more intensive testing on the stator and regulator rectifier but they were fine (I have videos on that if you’re interested). So far the new battery has fixed it though. Ride safe. And enjoy that awesome bike! 😆
@@FabMotorbikes just an update, ran the bike a few times since and got error 46, engine light on. Then all dash display gone, bike stutters and stops. Luckily both times I was close enough to push it home. I’ve replaced the rectifier months before thinking it was that, now I’m thinking I might need a new battery!
@@sabbage100 this sounds exactly like the problem I had. identical in every way. Battery was my problem too. Even after testing the stator and rectifier (both fine). Sometimes batteries just give up i guess. Thanks for the update!
Had the same with my fz6 was the rectifier that was bad. Get a voltage meter and check the stator and rectifier. Fault 12 is crank shaft position sensor
Thanks very much, will definitely keep that in mind. All seems fine now... But could go bad at any point. I intend to run a few tests once I get the proper tools for the job 👍cheers for watching.
Sorry i have a spain market model i try holding seclect button nothing happens.i had uk model before and it worked is there any other way to change kph to mph?
Thanks very much! Me too. Was a little to easy to fix though so might still not be completely it of the woods. Fault code 12 was the following >> “Symptom: No normal signals are received from the crankshaft position sensor. Probable cause of malfunction: Open or short circuit in wiring harness”. All codes have gone now mind you 👍
4 mm allenn key ? .. dude that is a Torx .. do NOT use an allen key in that :-s .. will mar it up. still wondering WHY would you leave the battery on the bike while stored .. all year bike or ? :) ty for the video btw
150% sure it’s a 4mm Allen key 😂 Ended up leaving the battery in way too long during covid lockdown’s I do admit. You’re welcome, I hope it was useful in some way
It depends if you have later s2 version. Which was introduced around 2007. One of the easiest way to tell is if you have a helmet lock? This should have a key slot and should be next to the key slot that releases your seat. Otherwise, I would always recommend inputting the year of your bike on the website you are purchasing from. Hope that helps. Let’s me know if you have any more questions 👍
It is always good to know where to look when getting fault codes on your motorcycle. So thanks for this useful information.
My FZ6 S2 is built in 2008 with 27,000 Km on the odometer and bought it from the first owner. I use the bike every day to drive to work and to tour in my spare time. Have a nice day and drive safe.
Thank you 🙏 you too
When installing additional electrical appliances like heated grips or phone charger i always use a 12V relay, that just cuts the power off when the ignition is turned off. You would get them for 3 Euros on ebay. They prevent your battery from being drained.
Thanks a lot I’ll look into that. 👍 definitely needed
Don’t use any of those phone chargers connected for the bike battery. There’s so many portable chargers now.
Thanks for the vid.
Agreed! Thank you for watching
The FZ6 Engine Control Unit loves to throw out spurious fault codes when the battery gets low and has been the result of more Crankshaft Position Sensors being checked (fault code 12) or even replaced unnecessarily than anything else!
If you can, get an Optimate or other battery tender which will greatly help keep the battery in good condition, although even that will have difficulties with a battery that's over about 5 years old.
It's a good idea to use a multimeter to check the output of your Regulator/ Rectifier and Alternator because if either of those is faulty they can kill a good battery by giving too little (or too much) power.
Also you can buy a Drop Tester from eBay or similar for around £20 which is a good way of seeing if the battery has dropped a cell and letting you know if it needs replacing.
Finally don't forget that a brand new battery can be duff as I found when I replaced one and then still had problems starting!
PS You can clear the old fault codes by using setting 62 in Diagnostic Mode.
Awesome thanks very much. I’ll definitely be getting some tools to test the charging system in the ways you described. I feel it was too easy of a fix on this occasion... worth double checking. Thanks for the comments and advice 👍
Love/loved my fz6 S2. Done 53k on it now and the last 6 months I have had nothing but electrical issues from stator, rectifier, fuel pump, immobilizer and coil packs.... Mechanically brilliant suspension and brakes are perfect just got he age where wires get a bit mardy...... Good video tho keep going.
I feel the same way about the bike. Absolutely love it. But it is entirely possible that it’s just getting to that age where wiring/electrics could start becoming and issue. Thanks very much, glad you enjoyed the video. I plan to do some more electrical tests once I have the tools fo it 👍👍
@@FabMotorbikes I managed to find an ECU and wiring harness to replace my aging one (ECU pins actually got corroded by water ingress) I'm sure it's going to be fine again once replaced but she's going up for sale as I brought a new steed already :)
Yea sounds like you’ve got it sorted. What bike have you got as your next steed?
@@FabMotorbikes a Kawasaki z750r.... Nothing mega fancy bit just loved the way it looked then I had a ride ... It's so smooth instantly fell in love ha bikes do weird things to your emotions ha
Yea I understand. Sometimes I turn down offers to ride other bike because it has lead me to going an getting one myself whe I have a perfectly good bike already 😂😂
I’ve always liked the z750. I don’t know much about the ‘R’ version. I assume it has a bit more aggressive/racing characteristics.
Thank you for so many videos so well explained!
Looking forward to new videos on your channel 🔥🏍️
Thank you 🙏
I have same the exact same bike. Had a new battery put in 6 months ago, left the bike outside untouched for a month and voltage dropped to about 10v (from the dash diagnostic), tested with a voltmeter and it’s about 11v. Anyway I whipped it out, plugged in on a trickle charger for about 6 hours, now it’s back up to 13v. Let’s hope it stays that way!
Good luck! Hope all runs well 👍. I ended up doing some more intensive testing on the stator and regulator rectifier but they were fine (I have videos on that if you’re interested). So far the new battery has fixed it though.
Ride safe. And enjoy that awesome bike! 😆
@@FabMotorbikes just an update, ran the bike a few times since and got error 46, engine light on. Then all dash display gone, bike stutters and stops. Luckily both times I was close enough to push it home. I’ve replaced the rectifier months before thinking it was that, now I’m thinking I might need a new battery!
@@sabbage100 this sounds exactly like the problem I had. identical in every way. Battery was my problem too. Even after testing the stator and rectifier (both fine). Sometimes batteries just give up i guess. Thanks for the update!
Had the same with my fz6 was the rectifier that was bad. Get a voltage meter and check the stator and rectifier. Fault 12 is crank shaft position sensor
Thanks very much, will definitely keep that in mind. All seems fine now... But could go bad at any point. I intend to run a few tests once I get the proper tools for the job 👍cheers for watching.
The rectifier has been replaced on my fz6 too, seems like a common issue.
@@OriginalUsername9000 cheers will keep that in mind 👍
Personally, I would have checked the main fuse first. But what I know about fixing bikes you could write on the back of a postage stamp😆
Good idea, to be fair 👍😉
nice video sir, love it.
Thank you very much!
how do you change from kph to mph?
If you hold down the ‘select’ button only for a few seconds, it will change from kph to mph. Thanks ride safe!
Sorry i have a spain market model i try holding seclect button nothing happens.i had uk model before and it worked is there any other way to change kph to mph?
I’ll do a little research and get back to you. I would have thought it Was possible
@@FabMotorbikes ok thank you
I’ve been struggling on this if I’m honest. It could be possible that European versions do not have this capability. Sorry if not much help.
Chuffed you got that sorted matey 👍 what was error code 12?
Thanks very much! Me too. Was a little to easy to fix though so might still not be completely it of the woods.
Fault code 12 was the following >> “Symptom: No normal signals are received from the crankshaft position sensor. Probable cause of malfunction: Open or short circuit in wiring harness”.
All codes have gone now mind you 👍
@@FabMotorbikes fingers crossed there's no more expense then 🤞
Nice video
Thank you 😊
Error code H1
4 mm allenn key ? .. dude that is a Torx .. do NOT use an allen key in that :-s .. will mar it up. still wondering WHY would you leave the battery on the bike while stored .. all year bike or ? :) ty for the video btw
150% sure it’s a 4mm Allen key 😂 Ended up leaving the battery in way too long during covid lockdown’s I do admit. You’re welcome, I hope it was useful in some way
@@FabMotorbikes sure looks like torx from the camera angle :D .. gz on making the girl purr again
Will she start... It's a Yamaha. Yes.👍
Haha! Always! The problem ended up being my lack of use and care 😂🤣 not Yamaha’s fault at all!
What year is your Fazer?
It’s a 2008 👍
Going from one of your previous videos about Mods to the fazer, would all the mods fit a 2007 fazer 600?
It depends if you have later s2 version. Which was introduced around 2007. One of the easiest way to tell is if you have a helmet lock? This should have a key slot and should be next to the key slot that releases your seat.
Otherwise, I would always recommend inputting the year of your bike on the website you are purchasing from.
Hope that helps. Let’s me know if you have any more questions 👍