@@sajjadshakeri877 sir for combining shaft and helix, we will have to decompose shaft into surface, then we will have to give properties of surface to both shaft and helix .
@@sajjadshakeri877 ok sir, thank you. Sir i am modeling shaft as embedded beam rather than volume, do you have any idea ,how to give support between embedded beam and helical plate other than node to node anchors ?
how can i contact you cuz i'm concerned about these helical piles
+989177735752
@@sajjadshakeri877 sir i have a few questions regarding helical piles analysis in Plaxis , can i contact you in whatsapp ?
Sir great video 👏but the helical plates are not connected to cylinder which will cause meshing error.Could u please tell me about its meshing part?
hi you can decompose the cylinder into the out lines. after that,loft surfaces that are not connected to each other by craeted lines
do u know , how to give pile properties to this geometry ?
sir how do we give pile properties to this element ?
Hi, for the inner shaft, define elastic property representative for steel behavior. for helical blad you should defile plate
@@sajjadshakeri877 sir for combining shaft and helix, we will have to decompose shaft into surface, then we will have to give properties of surface to both shaft and helix .
@@thespontaneoustraveller821 no need to decompose volume
Just model cylinder and helical blades
In meshing process they will attach to eac other
@@sajjadshakeri877 ok sir, thank you. Sir i am modeling shaft as embedded beam rather than volume, do you have any idea ,how to give support between embedded beam and helical plate other than node to node anchors ?
@@thespontaneoustraveller821 in this case you will face with mesh error
please continue our discussion on whatsapp
+989177735752