3.7v to 1.5v Power Supply for Wall Clock
HTML-код
- Опубликовано: 15 сен 2024
- #setnfix #wallclock
How many times you have changed the batteries of your wall clock?. I know it is not good to stop your clock. Therefore, I am planning to build a system for giving unlimited power for a low cost. Watch this video until end.
Check for Circuit diagram : www.setnfix.com...
--------------------- ABOUT SetNFix RUclips CHANNEL------------
This is SetNFix RUclips channel. If you are an #innovator, #DIY #lover or do not want to waste your time at home, this is the channel you should #watch. You can watch #Arduino Projects, #Electronic Projects, #Car repair #tips, #Computer Hardware and #software lessons, #iphone tips, #Android tips and much more.
Sign with this link and get 19 USD free
Contact : WhatsApp : +94723912788
Aliexpress : a.aliexpress.c...
💲Nano With the bootloader💲 s.click.aliexp...
💲ATMEGA 328💲s.click.aliexp...
💲100pcs 5mm LED💲 s.click.aliexp...
💲5pcs Relay 12v💲 : s.click.aliexp...
💲12x18cm single Side Prototype PCB💲 : s.click.aliexp...
Buy head unit with 55% discount : s.click.aliexp...
Car Cigarette lighter connector with 15% discount💲 : s.click.aliexp...
Car Headrest Unit Display with 16% Discount💲 : s.click.aliexp...
2Din car radio player with 50% discount : s.click.aliexp...
Portable Car Steering Wheel Wireless Controller with 24% Discount💲 : s.click.aliexp...
Waterproof Car External Receiver Antenna Repeater 45% discount: s.click.aliexp...
Car Dash Cam 1080P LCD Dashboard Camera 2.2" 50% Discount💲: s.click.aliexp...
You can follow us on
Earn Crypto Currency at home : cryptotabbrows...
Blogspot :setnfix.blogsp...
Website : www.setnfix.com
Arduino : create.arduino...
FaceBook : / setnfix
Hackster : www.hackster.i...
Reddit : / setnfix
twitter: / setnfix
kakao : story.kakao.co...
Instagram: / setnfix
Arduino : • Arduino Projects
Electronics : • Electronics
Automobile: • DIY Car Modifications ...
If you have not SUBSCRIBED my channel, do not forget to subscribe, like and share my videos
STAY WITH SetNFix
Find an LED with about a 2.2 Volt drop and this will lower the voltage to 1.5 Volts. Measure the LEDs drop through a 1K resistor. This is better than just resistors. A red LED and a Diode in series might give the 2.2 Volt drop as well.
Yes, but it may cause the battery to dry out early.
Yes, exactly because of led..
Bro, pls add subtitle
Here new subscriber...
The idea in this comment is much better than the video. The battery on the video will drain faster because of the continuous current flow on the resistors plus the parallel connection of the clock. The idea of using just LED or diodes in series is only one complete circuit and the current flow is pretty much the same as before, as long as you drop the voltage correctly.
I don't consoder this as a good work. You should require to try by you self first and then the final work submit for viewers. Back ground music is disturbing the ears. Placing of component and soding work was very poor.
Thx
sana katılmıyorum, gidiş yolunu göstermiş daha ne istiyorsun, sizlerde yapın ortaya bir iş çıkartın, çalışma gayet güzel......
.Hello, I want to use a 7.5 volt multimeter battery and adapt it and reduce it to 1.5 volts. Do you advise me to put in series a resistor, let's say for example of 3 k and another of 2 k + a capacitor of the same value as in the video???? I will install a 50 volt x 10 uf capacitor
capacitor is ok. and use 10k and 2.5k resistors as voltage divider.
Вед резистор потребляет ток, и нагрев. Батарея быстро разрежается. Это не правильное соединение....
Вы пробовали?
Love your effort....keep it up
Thank you.
Elco is a 50volt 10mf
yes
I rate your whack job in soldering a 3 out of 10. Do better next time. Eventually that battery will go low as well. The advantage is you can recharge. Better look for a solution with an active chip.
Thank you
Yes,try by using 1s 1amp module..
very good video but if it's without that horrible background music plZ don't add that again
Thank you.
Very nice sir ji.please give with diagram.Thanks GOD bless you.
Thank you,. link in the description.
Thanks I saw.Sir can you make 3.7volt to convert into 9volt for 9volt multimeter an idea.Thanks.
@@dilawarsingh8934 You can use like this ruclips.net/video/_mdvdTn8m2c/видео.html
value of two different resistance please
1.5k and 1k, www.setnfix.com/2023/07/37v-to-15v-power-supply-for-wall-clock_31.html
Why using two different value resisiter, when two 1.2 kilo ohm can use.
Battery drain itself
Not exactly
What a type diode?
no need a diode
@@setnfixelco or diode?