Very nice crystal clear HD video, enjoy watching it. Wish that there was sound to hear the explanation of the readings OR give us some signs like thumb up for good reading/thumb down for bad reading, etc.,.. that would be wonderful/perfect. I don't know 4.174 and 4.255 kohms good or bad. Thanks.
Too bad no sound but here’s my question I tested both solenoids by touching the white connector to each solenoid to see if it would open the valve, and it did ..so it means that my solenoids are good, my problem is the blue connector doesn’t seem to signal my solenoid even though there’s 220 volts from it..what seems to be the problem? The blue connector is for pre-wash/softener
Sir one problem is in LG TOP LOAD washing machine inlet valve have continous supply when machine main supply on means water continue on so if i checked at valve continous supply shown so pls suggest solution is it possible triac is on when main supply on
Good vid. I saw only anywhere from 2-6 volts on mine likely due to bad dmm probing procedures. I continued further and applied ~112Vac to the solenoid contacts from an extension cord with spliced ends which was plugged into another outlet. Both solenoids proved serviceable with water flowing through them. I think it's my On/Off push knob component that isnt allowing for voltage to get to solenoids :(
Very nice crystal clear HD video, enjoy watching it. Wish that there was sound to hear the explanation of the readings OR give us some signs like thumb up for good reading/thumb down for bad reading, etc.,.. that would be wonderful/perfect. I don't know 4.174 and 4.255 kohms good or bad. Thanks.
the haigher resistant bad silonoid 4.174 Kohm bad
@@minasmash what is the good resistance to it? Or what should be the resistance of the coil?
@@jepokractv5565 >500 but
4kohm is totally fine!!
If you drive them with 220V there is plenty of power. Some are more effecient then others. 500ohms could be for 110V.
Well That Didn't Teach Me Shit!
Inlet valve good. Nice job
Too bad no sound but here’s my question
I tested both solenoids by touching the white connector to each solenoid to see if it would open the valve, and it did ..so it means that my solenoids are good, my problem is the blue connector doesn’t seem to signal my solenoid even though there’s 220 volts from it..what seems to be the problem? The blue connector is for pre-wash/softener
Nice,brief and useful video
Nice, brief and useful comment.
so odd mine already show 220 volt when i measure it at on mode
what do you call that black and blue two pins connector i need to know
Need to learn how to fix your mic 🤣
Thanks for videos
Senthil gi aap ka kabhi comments nahi aata hai
Sir one problem is in LG TOP LOAD washing machine inlet valve have continous supply when machine main supply on means water continue on so if i checked at valve continous supply shown so pls suggest solution is it possible triac is on when main supply on
No sound. Thumbs down.
Good vid. I saw only anywhere from 2-6 volts on mine likely due to bad dmm probing procedures. I continued further and applied ~112Vac to the solenoid contacts from an extension cord with spliced ends which was plugged into another outlet. Both solenoids proved serviceable with water flowing through them. I think it's my On/Off push knob component that isnt allowing for voltage to get to solenoids :(
👍 Probably
I need one peace Toshiba washing machin model AW-B1000 Z inlet valve hwo l can arrange please help me 2:07
Sound?
in my WM voltage shows 45v
Not good.Find why there is no 240/120 voltage in the washer
יפה
תודה