I have an F1 Ultra in the other room. I bought it during the launch event. I haven't remade my own maker's stamp yet, but it's on the todo list. If you have a use for it, it is a great tool.
You can run what's called a clean up pass after you are done engraving. It is normally done at a higher frequency and lower power than your engraving run and will leave you with a nice surface finish which helps cut down on the cleanup time. May want to experiment a bit and see what your settings would need to be. I know on my 30W I run like 40% power and around 60KHz for freq and only do 1 pass so it's quick.
the xtool has a great user friendly ecosystem but 20h is way too slow, with a 50W fiber laser you can do 1mm per 10min approximately for the same price
Hey, awesome! We spotted our MOVE stamp in the video. After more than 300 uses, it's still as good as new. Thanks again for the great quality.
That is awesome!
I have an F1 Ultra in the other room. I bought it during the launch event. I haven't remade my own maker's stamp yet, but it's on the todo list. If you have a use for it, it is a great tool.
Nice👍🏽👍🏽👍🏽 I saw my logo there 😉 I use it a lot. Thx.
Imagine the details you could place on pieces of metal, like the rims of those glasses as an example. 👍
You can run what's called a clean up pass after you are done engraving. It is normally done at a higher frequency and lower power than your engraving run and will leave you with a nice surface finish which helps cut down on the cleanup time. May want to experiment a bit and see what your settings would need to be. I know on my 30W I run like 40% power and around 60KHz for freq and only do 1 pass so it's quick.
Will do. Thank you
thanks for the video
Wow. That's impressive
How long did the engrave take?
the xtool has a great user friendly ecosystem but 20h is way too slow, with a 50W fiber laser you can do 1mm per 10min approximately for the same price