Thank you, sir, for the knowledge given to the discussion about lifting loads on a drone propeller, that's amazing, because I already understand the discussion earlier, pray for me, I'm analyzing a drone propeller
It is the space which is covering all the rotating blades. It is needed for simulation. It is made manually by un-merged extrude boss base on the circular sketch
@@CFD_GUIDE Thank you for the reply. what i would like to add is that if I add this extrude. that will add up to the total mass of the drone unit right. how can I exclude it from the mass calculation ? another question is that, I have a propeller design , diagonally 1 set of propeller should be inverted compared to the other set ?
This may be due to the geometry. If it is an assembly convert it into a part and save as Sldprt file. Again unimportant parts keep inactive. Don't consider unimportant parts in your CFD analysis.
Thank you, sir, for the knowledge given to the discussion about lifting loads on a drone propeller, that's amazing, because I already understand the discussion earlier, pray for me, I'm analyzing a drone propeller
How can I manage the component Control ?
Can you explain how to create this dummy space around the propeller. is that important for doing the simulation ?
It is the space which is covering all the rotating blades. It is needed for simulation. It is made manually by un-merged extrude boss base on the circular sketch
@@CFD_GUIDE Thank you for the reply. what i would like to add is that if I add this extrude. that will add up to the total mass of the drone unit right. how can I exclude it from the mass calculation ?
another question is that, I have a propeller design , diagonally 1 set of propeller should be inverted compared to the other set ?
Yes inverted@@vishnudasmattappillilsathi2855
how to simulate the rotation , roll, pitch, yaw aspect of the drone. In the wizard setting, which coordinate system to be selected ?
Why is it saying mesh generation terminated? Could you please help!
This may be due to the geometry. If it is an assembly convert it into a part and save as Sldprt file. Again unimportant parts keep inactive. Don't consider unimportant parts in your CFD analysis.
Broo.. I cannot select the propellers in selection of rotating parts
You can select from solid components
@ERUDIRE PLUS Thank you very much。but SLDPRT version is too high。could you send me the model such as stp or igs ？Thanks。
bro design tutorial
Bro, can I look at it, analyze it on my laptop. can I ask you for a file of this work, please?