@@BC_Hunter That sounds right as long as you have the right back spacing you are good for the clearance for the ball joint. Then you just need to trim some plastics
I just picked up the same truck (24 Trailboss LT) and I'm looking at the same lift and tires. Great video, you've sold me on the idea. What brand of spacers were used?
How much space is there from the back side of tire to the new ready lift upper control arm ball joint with the new tires. I have the 2” ready lift but I have not changed out the tires due to spacing.
This is a factory 2 inch plus two from this lift so it would be similar to a 4 inch SST kit. If it is a cross member kit with Aftermarket spindles than you may need more clearance.
Looks great - just want to confirm there was no rubbing or trimming of the back front fender well with this setup?
Minimal Trimming off of the Mud Flap but nothing on the Fender itself
Hey sir did it slow down your exelleration any or power, it looks awesome!
No Complaints so far
Love it. Picking up my TB tomorrow and was planning on doing a 2” SST kit on 295/70/18’s.
There was a note speaking to Tech that the Factory 18 wheel was not compatible so make sure to get an offset wheel to complete this set up!
@@dsautomotivecollision I was told with a -12 offset it will work with minor trimming.
@@BC_Hunter That sounds right as long as you have the right back spacing you are good for the clearance for the ball joint. Then you just need to trim some plastics
.375 inch wheel spacers
Советую поменять UCA’s. Заводские ломаются при лифте.
I just picked up the same truck (24 Trailboss LT) and I'm looking at the same lift and tires. Great video, you've sold me on the idea. What brand of spacers were used?
Just the Rough Country 1/4 inch Spacers
How much space is there from the back side of tire to the new ready lift upper control arm ball joint with the new tires. I have the 2” ready lift but I have not changed out the tires due to spacing.
Laser tight but we were able to use the Stock 20 inch Wheel with the 1/4 inch wheel spacer with a 295x65R20 Nitto Ridge Grapplers
Can you run a quarter inch spacer with stock lugs?
@@richgardiner1900 Yes
Did you need to do a wheel alignment? Did you use the stock Rancho struts and just added a space on top of it?
We did have to align it after. The Factory Struts were reused with this kit!
thanks truck looks awesome..
Can you run 12.5s?
No they would be too wide to clear the Upper Control Arms
Could I do the same thing with an LTZ with a 4 inch lift?
This is a factory 2 inch plus two from this lift so it would be similar to a 4 inch SST kit. If it is a cross member kit with Aftermarket spindles than you may need more clearance.
Have same truck... put king suspension on it 35s with 18in method rims... took off the horrible trail boss sticker
Sounds Like a nice set up!
Does this have the 3” block in the back as well?
It has the Block Supplied with the Kit but it sat really level!
@@dsautomotivecollision Sounds good. Apparently the stock TB has a 2” block.