I followed your instructions, but when I try to connect using the telnet, it says "error failed to connect" and am unable to connect to enter the command.
I did connect to the hotspot first and paired the camera to the phone without problem. However, when I used telnet and entered the same information provided, it gives that error failed to connect. I am using firmware 1.5.27 thank you for your reply by the way, much appreciated. this loud startup sound bothers me so much...@@LaPalmeraie0032
Works like a charm thanks bro
😉 💪
Hi, thank you very much it worked!!
Btw, how to reverse it to original state?
Great! Just repeat the steps but inverse the names in the commando. Updating the dashcam will restore the original setting as well.
Thanks a lot man! I made it.
💪
How to turn off "enter parking surveillance mode after 5 minutes"
You do not want to go the camera in parking serveillance mode? If it is hard wired it will unless you turn the serveillance mode off in the settings.
I followed your instructions, but when I try to connect using the telnet, it says "error failed to connect" and am unable to connect to enter the command.
Make sure you connect to its hotspot first via the WiFi setting on your phone.
I did connect to the hotspot first and paired the camera to the phone without problem. However, when I used telnet and entered the same information provided, it gives that error failed to connect. I am using firmware 1.5.27 thank you for your reply by the way, much appreciated. this loud startup sound bothers me so much...@@LaPalmeraie0032
which ssh application u used yea?
@mochademandy hi! I used iTerminal. 😉