Please, can you help me? I bought the camera and the film winder doesn't move far. Just for 20-25 degrees. It is because I didn't put the batteries? Or this issue doesn't connected with the batteries?
Hi, If the light in the viewfinder always red instead of yellow, maybe light meter has a problem. Reference description "Fully Automatic Electric-Eye Contro" below: 1. Looking through the viewfinder at your subject, push the shutter release button down slightly to determine the light level and picture taking mode. A. if the green lamp in the upper left corner of the viewfinder lights up and then goes out as you continue to push the shutter release, light is adequate for normal hand. held auto exposure without flash, and you can proceed to take the picture as soon as you have focused and composed your subject. B. If the green lamp does not go out but changes to red as you continue to depress the shutter release button, a shutter speed slower than 1/30 sec, is indicated, and use of a tripod is recommended if you are not using flash. Your Himatic E will continue to make accurate auto exposures down to 2 full seconds without flash. Adequate attention should, of course, be paid to subject movement at slow shutter speeds. It is important to remember, at these slow shutter speeds, that you MUST HOLD THE SHUTTER RELEASE BUTTON DOWN UNTIL THE RED LAMP GOES OUT. If it is inconvenient to look into the viewfinder, as under certain conditions when using a tripod, instead watch the battery check lamp, which lights and goes out in parallel with the viewfinder's EE indicator lamp, and keeps the shutter button or cable release plunger depressed until it goes out. CAUTION For normal EE exposure, be sure the flash selector is set at AUTO. Never set it at MANUAL when you are not using flash. Hope it helps you.
Like watching stylized animation
How too connect electronic control bcz i have this camera but noo battery
Please, can you help me? I bought the camera and the film winder doesn't move far. Just for 20-25 degrees. It is because I didn't put the batteries? Or this issue doesn't connected with the batteries?
When there is no battery, the shutter cannot be fired, advance lever will get stuck, can only move a small margin until you release the shutter.
What type of battery are you running in this camera?
PX640(1.35V)
@@binheng where can you buy these?
Please search "PX640 Battery Converter Adapter", will find very lot of on eBay.
Full HD in like 12fps.
Hi! I can't seem to focus my photos. The light in the viewfinder after clicking is red instead of yellow. What do you think is the problem? Thanks!
Hi, If the light in the viewfinder always red instead of yellow, maybe light meter has a problem.
Reference description "Fully Automatic Electric-Eye Contro" below:
1. Looking through the viewfinder at your subject, push the shutter release button down slightly to determine the light level and
picture taking mode.
A. if the green lamp in the upper left corner of the viewfinder lights up and then goes out as you continue to push the shutter release, light is adequate for normal hand. held auto exposure without flash, and
you can proceed to take the picture as soon as you have focused and composed your subject.
B. If the green lamp does not go out but changes to red as you continue to depress the shutter release button, a shutter speed slower than 1/30 sec, is indicated, and use of a tripod is recommended
if you are not using flash. Your Himatic E will continue to make accurate auto exposures down to 2 full seconds without flash. Adequate attention should, of course, be paid to subject movement at slow shutter speeds. It is important to remember, at these slow shutter speeds, that you MUST HOLD THE SHUTTER RELEASE BUTTON DOWN UNTIL THE RED LAMP GOES OUT. If it is inconvenient to look into the viewfinder, as under certain conditions when using a tripod, instead watch the battery check lamp, which lights and goes out in parallel with the viewfinder's EE indicator lamp, and keeps the shutter button or cable release plunger depressed until it goes out.
CAUTION
For normal EE exposure, be sure the flash selector is set at AUTO. Never set it at MANUAL when you are not using flash.
Hope it helps you.
It will not work without the battery?
yes.
What type of battery is it?
I bought the same camera, but when i push the shutter button, the shutter does not open all the way...
You can simply depress the shutter release button slightly to check the condition of the batteries.