How to connect the combustion control unit to the gas supply on a Baxi Heat only boiler

In this #TrainingTuesday video, Baxi Trainer Andy shows you the best way to connect the combustion control unit to the gas supply on the Baxi Heat only boiler range.
Please note: This video is intended for competent heating and hot water engineers only, for example must be Gas Safe registered if working with gas, or have the Unvented Hot Water Qualification (G3) and is subject to our full video disclaimer which can be found here:
www.baxi.co.uk/important-information/video-disclaimer
#BaxiTraining
#heatingengineer
#gasengineer
#installer
#BaxiBoiler
#TrainingTuesday
#heatonlyboiler
For full details of our training offering, visit www.baxitraining.co.uk

[@pro-powerflushing]

Looks rite enough to me Andy 💪

[@tka.754]

Are you sure you ldf the fibre washer joint?

[@charlieteer6162]

Does the gas valve come preset ? 0.4 between the low and high ?

[@mikefewtrell2061]

Andy the toggles went up not down 😂😂😂 sorry nitpicking 😂😂 but good job as always.

[@prawnk1ng]

4:30 why would there be bubbles?
Your gas isolator was still in the off position, no ?

[@waynenixon729]

That's exactly what I was thinking. Safe isolation should be done before even touching the cover, just in case there is a fault and the case is live.

[@mikefewtrell2061]

And those bottom screws are a pain to get back in 😢

[@pollywollydo]

Designed by a committee ?🤭