JEEP TJ TRAILING ARM FRAME REPAIR! DIY
HTML-код
- Опубликовано: 3 июн 2021
- it took a very long time and i do apologize, i am going to do my best this summer and try and get as many videos out as possible for you guys, thank you all for supporting me and what i do.
now get out and create something of your own!
FOLLOW ME
INSTAGRAM /
TWITTER / abmxriderr
SNAPCHAT TYMAN4297
TIKTOK A.BMX.RIDERR 
Авто/Мото
Just a little advice on your first lower control arm bolt you were struggling with.
If you turn the nut side vs the bolt side, it’s much less force that is needed to remove the nut from the bolt.
Trying to break free the nut by turning the bolt is much harder in many cases .
Thanks for sharing! I am about to start on my TJ frame repair shortly.
Thanks for the Video, helped a lot.
Starting on left side of my 98 now :-)
When I did mine I removed the gas tank and cut the replacement parts down about an inch so I could get a decent bead on the top, and even with that it was not that easy, dryer vent cleaner brush on a drill on inside of frame, blow it out and coat it with eastwood inside frame treatment, oh and it would have been nice to have a lift like Ty
I have to do the drivers side on my tj I ordered the part I figured since I have to do the fuel pump it would be easier to do with the tank off
Helpful video. Suggestions: when holding the camera and moving around...SLOW DOWN and pause on the subject that you are discussing! You pan way too fast. I found the music to be irritating, not choice but volume, every time the music started, I had to turn my volume down and then back up again. Also, I suggest that you answer most or all of the comments, at least acknowledge, that is if you want your channel to grow.
Fluid Film the inside of your frame. I thought all Canadians used fluid film. LOL
So do you have to cut out the rust spot?I think I the plates I ordered just slip over the frame
Would you do the driver side for someone not far away
Where did you learn to weld?
What brand was the frame repair kit? I know you might have said it but just so its here to see
Safety- cap
What type of welding did you use and what setting did you have it on?
It was a welder from Amazon. If you check out my other video on it and i can’t remember the settings. It was just a lot of fine tuning to get it right
Did you leave the gas tank on while cutting and welding?
Yeah just did our best to aim sparks, away from it. Probably a good idea to remove it if your doing the job your self
tripod....
You should've spent more time with your templates & you wouldn't have had to guess, by lowering it to the ground.