Local Preference ISP1 routes @21:49 & 33:12 , Pre-pend ISP1 to select R1 for subnet 11 @29:10, Pre-pend ISP2 for R2 @33:39, Local Preference for ISP2 @39:22
thanks for sharing relevant scenario close to production setup. Make video on production multicast scenario which is being used in iptv service or in DNS service providers.
I think there is some configuration issue here both R1 and R2 default route next hop should be ISP A then the traffic other from AS 200 and AS 300 will go out from ISP 1
BGP is ideal to be used on Load sharing , static routing might achieve that however that is not practical/recommended specifically in large network setup
Really helpful the sessions
Very Good Explanation..
Thanks for your time on sharing this information.
Local Preference ISP1 routes @21:49 & 33:12 , Pre-pend ISP1 to select R1 for subnet 11 @29:10, Pre-pend ISP2 for R2 @33:39, Local Preference for ISP2 @39:22
Thanks Bro....semma useful.
Good explanation.. Thanks buddy
thanks for sharing relevant scenario close to production setup. Make video on production multicast scenario which is being used in iptv service or in DNS service providers.
I think there is some configuration issue here both R1 and R2 default route next hop should be ISP A then the traffic other from AS 200 and AS 300 will go out from ISP 1
Tarun Arora agree
Scenario is great just like production but explanation is not proper
you have not advertised route 155.x.x.x from both ISP1 and ISP2
How can we configure same setup on Juniper MX routers?
very good
I want to implement dual isp load sharing but my knowledge limited. (I never have known BGP before)
ASA200 should send default route to ASA 100 ....how did you achieve it..i cannot see any access list or route map..to influence traffic
Why IBGP through a switch and not do a direct link from R1 to R2??
ebgp multi-hop 2 command needs to be there between ebgp peers
no need to give ebgp multihop command here neighborship is not built from loopback ip
Can you create a failover video for the same
sir what will be configuration if I have both isp links on R1 and want to reach at R5 (aspect R5 is a cloud router ) with equal load balancing
Give maximum path 2 in bgp configuration
Audio is very low.
Sandeep bhai too boring sessions
can I configure load sharing without BGP sir?
BGP is ideal to be used on Load sharing , static routing might achieve that however that is not practical/recommended specifically in large network setup