Hi, if i were to replace the 4 back up sensors with new ones, will the park assisst work again? The park assist on my vehicle is completely dead, even with a new module.
If it’s the same body style as the Jeep in the video, it might be the same procedure to remove the bumper. After watching the video check your jeep to see if all the screws and clips are located in the same place as the ones in the video. If you have any sensors you might have an extra step to unplug those, if any at all.
This really helped. Great video. Thanks
Bon travail, merci 😊
Helpful video!
Glad it was helpful!
Great video
Glad you enjoyed it
Thanks!
Lmao I should’ve watched this first, I have a small tear where the 10mm was.😅
All good, you live and learn.
Can you replace the sensor molding without taking off the bumper?
you can try.
Hi, if i were to replace the 4 back up sensors with new ones, will the park assisst work again? The park assist on my vehicle is completely dead, even with a new module.
The sensors should work just fine but, the new module might have to be recalibrated if you replaced it.
Nice
Thank you!
hi, would the 2009 grand cherokee be the same procedure to remove the rear bumper?
If it’s the same body style as the Jeep in the video, it might be the same procedure to remove the bumper. After watching the video check your jeep to see if all the screws and clips are located in the same place as the ones in the video. If you have any sensors you might have an extra step to unplug those, if any at all.
Them 10 meter nuts spin mate then I finally got them out they seem clued to the plastic bracket from the back did you come across this
If it’s spinning and not loosen up, it’s broken