How to Remove & Install your Front Bumper 22+ WRX

Поделиться
HTML-код
  • Опубликовано: 10 дек 2024

Комментарии • 23

  • @paintsplatta99
    @paintsplatta99 Год назад +11

    Dude, THANK YOU for this. That little rubber flap in the front groove was the culprit for me and I spent 2 hours trying to get this back on. For whatever reason, every single other video that shows the bumper removal neglects to show the re-installation and that is by far the trickiest part.
    For others still needing help: once the bumper is anchored at the top, wrap your fingers around the very bottom edge of the black plastic in the front and feel for a little thin rubber sheet. Hold that down and pull out/back until the sheet slides under the intruding part that rests above it. This was the trick that did it for me. The plastic intruding part of the car was in the fender groove that he mentioned but the little rubber sheet was bunched up and it blocked the front fastener holes from lining up.

  • @mmyers6748
    @mmyers6748 2 месяца назад +1

    Bruh . I been struggling with this haha. Got a sub from me. That bottom part was getting me.. this made it so easy now. Thanks

    • @JoeyMontalto
      @JoeyMontalto  2 месяца назад +1

      Thanks for the sub! I have other install videos too. Lmk if you need help 👍🏻

  • @asibley1864
    @asibley1864 9 месяцев назад +2

    Super helpful, much appreciated man.

  • @Bossk077
    @Bossk077 Год назад +7

    I just want to say plenty interesting, but wasn't expecting this to pop up in Muyskerm's PayDay 3 playlist😅

    • @thes2kguy
      @thes2kguy Год назад

      I guess we know what Bob is driving 😂

    • @Bossk077
      @Bossk077 Год назад

      @@thes2kguy he mentioned on Distracible that he got a new grill for his car. I guess he needed help installing it.

  • @MattN03
    @MattN03 7 месяцев назад +1

    That bottom had me stuck too until i found your video. Thanks!

  • @jeffrenz14
    @jeffrenz14 9 месяцев назад +2

    Thank you 🙏🏽

  • @colew2178
    @colew2178 Год назад +3

    I’ve been trying to put it back on for over an hour after putting a sport grill on and a splitter. Do you think the screws for the splitter would be an issue or prevent it from lining up right

    • @JoeyMontalto
      @JoeyMontalto  Год назад

      The screws on my front lip were not effecting me installing the bumper. I don’t think there will be any issues with having a splitter installed

  • @andrewthomolaris6874
    @andrewthomolaris6874 5 месяцев назад

    Hey Joey, I just had my front sports grill installed and the sides of my bumper and the bottom seem a little loose. Is this normal?

  • @tommieboi707
    @tommieboi707 7 месяцев назад

    I installed the grill today and broke 2 of those push clips lol. Have to go get some more from local subie dealer tomorrow

    • @josecerrud1079
      @josecerrud1079 4 месяца назад +1

      Those clips are much cheaper at car shops.

  • @NikNikJuice
    @NikNikJuice Год назад +1

    Is there a front camera in the grill?

    • @JoeyMontalto
      @JoeyMontalto  Год назад

      There is not a camera on mine but there is a small piece that can be removed on the grille for the jdm camera. Not sure if there is a way to hook up the jdm camera

    • @NikNikJuice
      @NikNikJuice Год назад +1

      Noted. Thanks. Didn’t want any surprises pulling the bumper off a limited. Someone mentioned that the directional headlights operate based on a front camera.

    • @JoeyMontalto
      @JoeyMontalto  Год назад +1

      @@NikNikJuice direction of the beam would be controlled by the steering angle sensor. The auto high beams are controlled by the front camera on the windshield/rear view mirror.

  • @Claustropbaoeia
    @Claustropbaoeia Год назад

    How about "how to walnut blast the fa24.."

  • @JustisFlame
    @JustisFlame Год назад +1

    Oh god I’m about to attempt this but it intimidates me for some reason