replacing the sensors on our RV tanks (grey and black)

had a issue with our sensors not reading on our grey tank last time we went camping. black tank was fine, but decided to do all of them. total of 8 sensors. assuming they were original is also why i replaced them all.
got them from amazon, if you type in rv sensors they will pop up. not a hard job to do but the position of them make it tough, good luck

[@kurtv4946]

My gray tank reads 2/3 full regardless of how much water I have in it. I have tried cleaning the tank by filling it with dish soap and water and flushing it out to no avail. Nice to know the sensors are easy to replace.

[@360Fishing]

@@kurtv4946 had the same issue, once I replaced them, they read right.

[@rileyoflife6520]

You probably shouldn’t use axle grease because that type rubber isn’t resistant to petroleum products. I would suggest a silicone lubricant.

[@46fd04]

Nice video. I would use dishwashing soap instead of grease. Grease may damage the rubber.

[@360Fishing]

6:20 for the removal and installation of a sensor