Hi! Why don't you use an angle grinder to break the chain?! It's much easier and faster... Then you only have to pull through the new chain connected to the old one by the opened link. Next step is to remove the rear wheel. Then pull out the sprocket holder first, so you can easily loose the bolts in the vise. Next and most important step is to grease the rubber bushings of the rear sprocket holder to prevent abrasive wear there. Then the rest can be done as shown. I would use a so called superpinion as the front sprocket, because the transalp has sometimes a weak gearbox output shaft, in order to prevent extensive wear at this point. In the end there's no need to remove the upper and lower chain gaurd...
Hi mate, can you tell me how many link size your chain was? My manual says 110 link for the 650 transalp but it's 7 inch too short. I was told to use a 118 link but didn't know if it would need shortening or go straight on.
First of all thank you for the video sharing, it was very informative. Have you done any work on the rear brake pads when removing and installing the rear tire?
Glad you found the video helpful. No, I did not dismantle the rear brakes. The brake saddle is held in place by the rear axle, and a groove on the inside of the right swingarm frame. Once you remove the axle, the brake saddle is loose, and can be pulled off the disc. Installation is just a reversal of these steps.
I like the way you work on your bike - thorough workmanship ! Good job
Hi! Why don't you use an angle grinder to break the chain?! It's much easier and faster...
Then you only have to pull through the new chain connected to the old one by the opened link.
Next step is to remove the rear wheel.
Then pull out the sprocket holder first, so you can easily loose the bolts in the vise.
Next and most important step is to grease the rubber bushings of the rear sprocket holder to prevent abrasive wear there.
Then the rest can be done as shown.
I would use a so called superpinion as the front sprocket, because the transalp has sometimes a weak gearbox output shaft, in order to prevent extensive wear at this point.
In the end there's no need to remove the upper and lower chain gaurd...
Hi mate, can you tell me how many link size your chain was? My manual says 110 link for the 650 transalp but it's 7 inch too short. I was told to use a 118 link but didn't know if it would need shortening or go straight on.
Great video. Thank you!
First of all thank you for the video sharing, it was very informative.
Have you done any work on the rear brake pads when removing and installing the rear tire?
Glad you found the video helpful. No, I did not dismantle the rear brakes. The brake saddle is held in place by the rear axle, and a groove on the inside of the right swingarm frame. Once you remove the axle, the brake saddle is loose, and can be pulled off the disc. Installation is just a reversal of these steps.
What year is your transalp?
El piñon se le cambia también