Hello, I watch the 918 video on RUclips. Thx for your share. How do u solve the problem about the 360 degrees turning? Is there by a 3D printing part(instruction page 150)? Or just using the original Lego part?
Hi, essentially there are two rigid hoses, each with a 90 degrees bend from the turntable to either the superstructure or the undercarriage in order for it to not rotate. one pneumatic rubber hose is then used as a sliding seal, with can be laterally fixed further with either a 1 x 1 round brick, or the 3D part you saw in order for this seal to stay in the middle of both rigid hose. I messed up the 90 degree bend and the placement of the 1 x 1 brick, so i resorted to the 3D part with is easier to insert afterwards than the brick. I hope this clears things up, best regards!
Awesome MOC
Hello, I watch the 918 video on RUclips. Thx for your share. How do u solve the problem about the 360 degrees turning? Is there by a 3D printing part(instruction page 150)? Or just using the original Lego part?
Hi, essentially there are two rigid hoses, each with a 90 degrees bend from the turntable to either the superstructure or the undercarriage in order for it to not rotate. one pneumatic rubber hose is then used as a sliding seal, with can be laterally fixed further with either a 1 x 1 round brick, or the 3D part you saw in order for this seal to stay in the middle of both rigid hose. I messed up the 90 degree bend and the placement of the 1 x 1 brick, so i resorted to the 3D part with is easier to insert afterwards than the brick. I hope this clears things up, best regards!