How to Disable and Enable on the CTEC CFP Panel

Visit our website at. www.comsec.ie/
Visit our online shop at. shop.comsec.ie/
This video demonstrates how to Enable and Disable Zones and other functions on the C-Tec CFP Fire Panel

[@peterbrehaut3780]

When these panels are in walk test is there a way to also disable the sounders so you could walk test the smoke or heat detectors without sounding the bells each time. This is more for testing in office areas over many floors.

[@tommcmahon3453]

Have you found out?

[@tommcmahon3453]

Is there a way to disable sounders whilst In walk test or would you need to pull the connection direct from the sounders?

[@peterbrehaut3780]

No not that I have found . Pull out the legs in the panel or just have to put up with it.

[@TheOutdoorlife78]

With the key on active ! If no alarm is sounding and I pressed silent ! Would that set the fire alarm off within the building?

[@ComsecProtectionSystems1]

No

[@TheOutdoorlife78]

@@ComsecProtectionSystems1 thank you 🙏 also should the key be on active all the time ? I believe not only emergency testing or a alarm 🚨

[@luf2867]

Is there a way to turn this off without a key? My housing association took the key and the fire brigade came and left without turning it off (probably don't have a key).......There is no fire but it has been going now for about 2 hours and it is a Sunday so the housing is closed.

[@ComsecProtectionSystems1]

You can use the code 2143 and push silence

[@luf2867]

@@ComsecProtectionSystems1 Thank you.......Yesterday the alarm was going for 2 hours and it is linked in my flat to one of those old red bell alarms which is way too loud.........Was driving everyone in the building insane as we all have those bell alarms and they can be herd by our neighbors down the street they are that loud.......At least now I know how to turn the thing off when the key goes missing again.

[@stayinkent472]

@@luf2867 do you press 2142 on the white buttons above or the bottoms on the side?

[@kevinmathew1989]

@@ComsecProtectionSystems1 thank you. I'm in UK now. Same thing happened now. I called fire force. They were helpless. I saw ur comment nd try the code . It was successful. Thanks a lot

[@BloodDrippnFlowers]

Thank you so much asking this

[@thenododonnell]

Put it off?

[@perpetualintellectual2026]

I have someone who called today about a general fault on zone 3 what is the most common iissue for this?

[@Dime_Bar]

Someone has removed a detector to have a smoke and not refitted correctly

[@Dime_Bar]

@Unknown2Earth yes try and reset it, if fault comes back then check that all the smoke detectors are fitted correctly.

[@vincentvanwyk5522]

How do I disable the entire panel.

[@Dime_Bar]

Discount the batteries and turn the mains off

[@royaldhaliwal4509]

How can I access a panel with a code Please let me know thanks

[@issamaharras3213]

Reset

[@issamaharras3213]

2143

[@seanbates-fox4404]

@@issamaharras3213 thank you so much

[@Dime_Bar]

2143 if you've lost the key.