Thank you. John Lewis are asking for £30 to swap the doors on a Fridge Freezer. Two doors but no handles. I think I could easily do this in a Bosch. I think the hardest part would be getting it onto the ground and then getting it back up again!
It is quite easy on most fridge freezers, Bosch are normally ok, but you are right that it is lying it down properly that is the difficult bit to make sure you don't damage the floor, fridge freezer or more importantly that you don't hurt yourself. Be careful if you try it, but i am sure you will be fine.
Very helpful and clear guidance for anyone to follow
Well Done.
Very helpful, thank you
thank you so much, been planning on changing my door and was just lazy, but it seems rather effortless!
thank you for your hard work!
Thank you for this wonderful video! Really helpful!
I put my fridge on its back but now all me eggs are broken :(
How do know what tool you need, screws that will not move?
Would this be the same for a hotpoint H55ZM 1110 W UK? Because I can't find a video for that anywhere!
Yes it is pretty much the same process
You wont need to pay Hotpoint to do it you should be fine to do it yourself. Good luck.
Thank you. John Lewis are asking for £30 to swap the doors on a Fridge Freezer. Two doors but no handles.
I think I could easily do this in a Bosch. I think the hardest part would be getting it onto the ground and then getting it back up again!
It is quite easy on most fridge freezers, Bosch are normally ok, but you are right that it is lying it down properly that is the difficult bit to make sure you don't damage the floor, fridge freezer or more importantly that you don't hurt yourself. Be careful if you try it, but i am sure you will be fine.
Hi, is it this easy on a current Indesit undercounter integrated freezer?
Must admit i haven't got one on display at the moment, but integrated freezers on the whole are easy to reverse the door.
I put my fridge on its back like the video says. Now fridge won’t work. Any ideas why?
You may need to let is stand upright for a couple of hours to let the compressor gases settle
Did you just call torx 'tor-ex' instead of 'torks'? Oops!