Moment på skruvar på Stiga Park. Workshop Manual Stiga Park General tightening torque Unless otherwise stated the following tightening torque are applicable for screws and nuts on the machine. General Thread/Torque on Siga Park Senator, President, Royal etc according to workshop manual M5 - 5 Nm, M6 - 9 Nm, M8 - 22 Nm and M10 45 Nm. Happy repairing! 😅
💥💥 Please subscribe and press the like button ... 🙂 and if you want, please write a comment 😁 💥💥 💥💥prenumerera gärna och tryck på gilla 👍 Och om du orkar så skriv en kommentar 💥💥
If my lawn mover after moving up all to one side iand after putting back to driving position is starting to drive heavy and i heard the sound so it means that oil is missing or there is more trouble ?
Jag har en stiga tornado 2098 från 2014 och har märkt att den är väldigt trögväxlad. Det är ju ingen hydrostat på den men finns det olja eller fett i den transmissionen?
My mower loses power when hot to wear it will barely even drive I'm at the point where I need to tear down this transmission I'm not sure if it could just be a clogged filter or if maybe there's a problem with the axle seals. When I change the oil in it it was very very hard to fill up the transmission again because it didn't want to take any oil I had added a little bit at a time and it took me a whole day to get a level back in it I'm not sure why that was. Do you have any answers or advice
Hi! To fill the oil faster you kan remove the plastic plug as shown in the video, this vill make it in a few minutes. About the drive it sounds like the there are some scratches on the hydraulic pump or motor. Then it needs to be reworked. Best regards Tor
Thanks for your documentation about disassembling the transmission! Am i right, that you filled it up to the top With oil? I Saw some other Videos about changing fluid and they used about 2 Quarts (2 litre). Thanks for your work and keep up the work and swedish talking in the background. Always nice to have friends around while working on engines and other things
Hi! And thanks for your comment. In this drive it should be filled with oil and then on the lawnmower there is a small container that shall be filled. Unfortunately I don’t know how much oil I filled because I used a pump. But any way this one should be absolutely full Thanks and have a nice day!
Well, I agree that it would have been nice to see but it’s quite simple. It’s just a face honing machine with a manual pice holder. But I did it in the factory wher I work and ther is no photo or filming allowed So sorry about that!
Very nice teardown..and good info..my k46 suffers simmiliar (loosing some power when really hot). I wondered if pumps could get machined to remove marks..and you answered that question (i would hate to buy rebuild kit - costs a fortune ).
Min kasse har ingen drivning längre. Saknade inte olja. Filtret såg illa ut. Kan det göra så att man tappar drivningen? Undrar oxå på om drivningen kan justeras med den bulten som har fyrkantig bult huvud med en låsmutter på? Tacksam för svar
Great video. I have a question you might be able to help with. I have a 1990 Ariens tractor that is have a issue. The mower wont move forward and make a whining sound...it move backward strong and fast...just not forward. The belts seem to be tight, the fluid seem to be full, the linkage seems to be moving. The mower is in super good condition and hope to save it. Any help would be great...Thanks
Moment på skruvar på Stiga Park.
Workshop Manual Stiga Park
General tightening torque
Unless otherwise stated the following tightening torque are applicable for screws and nuts on the machine.
General Thread/Torque on Siga Park Senator, President, Royal etc according to workshop manual M5 - 5 Nm, M6 - 9 Nm, M8 - 22 Nm and M10 45 Nm.
Happy repairing! 😅
Tack ska du ha!
💥💥 Please subscribe and press the like button ... 🙂 and if you want, please write a comment 😁 💥💥
💥💥prenumerera gärna och tryck på gilla 👍 Och om du orkar så skriv en kommentar 💥💥
Wow many thanks for this video. I always wondered what the K46 looks inside. Incredible level of information.
Thanks a lot
Can you show the process for polishing the pump?
Jag vill gärna också se det🙏🙏
If my lawn mover after moving up all to one side iand after putting back to driving position is starting to drive heavy and i heard the sound so it means that oil is missing or there is more trouble ?
It’s very difficult to say with out knowing what kind of gearbox and drive it is
Jag har en stiga tornado 2098 från 2014 och har märkt att den är väldigt trögväxlad. Det är ju ingen hydrostat på den men finns det olja eller fett i den transmissionen?
Hej!
Ledsen men jag har ingen aning, har aldrig tittat på en sådan.
Mvh Tor-Arne
My mower loses power when hot to wear it will barely even drive I'm at the point where I need to tear down this transmission I'm not sure if it could just be a clogged filter or if maybe there's a problem with the axle seals. When I change the oil in it it was very very hard to fill up the transmission again because it didn't want to take any oil I had added a little bit at a time and it took me a whole day to get a level back in it I'm not sure why that was. Do you have any answers or advice
Hi!
To fill the oil faster you kan remove the plastic plug as shown in the video, this vill make it in a few minutes.
About the drive it sounds like the there are some scratches on the hydraulic pump or motor. Then it needs to be reworked.
Best regards
Tor
Thanks for your documentation about disassembling the transmission! Am i right, that you filled it up to the top With oil? I Saw some other Videos about changing fluid and they used about 2 Quarts (2 litre). Thanks for your work and keep up the work and swedish talking in the background. Always nice to have friends around while working on engines and other things
Hi! And thanks for your comment.
In this drive it should be filled with oil and then on the lawnmower there is a small container that shall be filled. Unfortunately I don’t know how much oil I filled because I used a pump. But any way this one should be absolutely full
Thanks and have a nice day!
Would have like to see how you polished the pump. That's like the main issue.
Well, I agree that it would have been nice to see but it’s quite simple. It’s just a face honing machine with a manual pice holder. But I did it in the factory wher I work and ther is no photo or filming allowed
So sorry about that!
Very nice teardown..and good info..my k46 suffers simmiliar (loosing some power when really hot). I wondered if pumps could get machined to remove marks..and you answered that question (i would hate to buy rebuild kit - costs a fortune ).
Thanks and good luck!!
Great video! one question: What did you use to polish there center base plates?
I have a lapping machine at work, manual but high precision
Is any way to polish the surfaces by hand?
It depends on the damage, if it only scratches it can be polished by hand. In other cases you need a good lapping machine
thank you , it help me alot to fix my transmission
Thanks! Nice that it helped a little
Hi! I made the rebuild but when i use the mower the forward end the backward exchanged?! What can be the problem?
Min kasse har ingen drivning längre. Saknade inte olja. Filtret såg illa ut. Kan det göra så att man tappar drivningen? Undrar oxå på om drivningen kan justeras med den bulten som har fyrkantig bult huvud med en låsmutter på? Tacksam för svar
Great video. I have a question you might be able to help with. I have a 1990 Ariens tractor that is have a issue. The mower wont move forward and make a whining sound...it move backward strong and fast...just not forward. The belts seem to be tight, the fluid seem to be full, the linkage seems to be moving. The mower is in super good condition and hope to save it. Any help would be great...Thanks
I have a- k51A-sBr.
I wonder which bolts were to drain the oil?
This really helped me a lot! Thank you so much dear Sir!
I am so delighted to be able to help!
Thanks for the video . Greetings from Denmark . I subscribed 🤗
Tanks for watching 🙂
I was hoping to see the resurfacing of the parts.
Hello, what oil you used?
Hi, I used Standard 10W30 oil. And have done so for many years
Vad var det du gjorde med pumpmotorn mer exakt? Mvh
Hur mycket olja går det i ungefär ?
Great video
Thanks a lot!