Setup Dial-up Connection & Convert to Wi-Fi Hotspot | No Router Needed

[@joibangla6795]

I've been searching for this very long. thank you very much

[@openmind2161]

You don't need the hotspot creator ,when your command shows hosted network started it means it already created hotspot

[@sonyahmedse8998]

Thank you for uploading this video

[@aniruddhamotegaonkar2059]

after 3rd command i got this
The hosted network couldn't be started.
The group or resource is not in the correct state to perform the requested operation.

[@xiNix_O]

same problem

[@yashofficial6]

@@xiNix_O same

[@techmanifested2752]

Solution is in the end of this video.

[@varunadhav7512]

@@techmanifested2752 I'm facing these 3 issues :
1. While connecting via mHotspot it says "Driver problem found !" but there' no way to fix it, i tried troubleshooting and updating the driver its still not working.
2. In cmd after entering "netsh wlan show drivers" it says Hosted Network Supported : No.
3. And after entering netsh wlan start hostednetwork it says The hosted network couldn't be started. The group or resource is not in the correct state to perform the requested operation.
Anyone help me through this.

[@MDRahat-xd7jn]

I use modem putting a sim to use interne so how can i use wifi hostpot?? please help

[@munnypriya4455]

In mHotspot it was showing Hotspot:OFF even though my hotspot is on in laptop.. can i know what is the reason

[@techmanifested2752]

Some PC shows hotspot off in mHotspot, but your connection will be enabled & hotspot too.

[@sabbirahmedsony7193]

Very helpful

[@techmanifested2752]

Glad to hear that

[@MasudRana-bi2cy]

Hotspot connected but Internet not accessing why??

[@techmanifested2752]

Please watch the full video.
Should be driver problem.

[@tunesoftech7668]

like it

[@fariba_bi2490]

thanks a lot