Thank you for this tutorial, i was trying the same thing for the last few days. I watched many videos about this and everyone skipped the cruical step where you have to input the correct input/output addresses in master project. Many thanks and keep up the good work.
@Jimmy PLC ok. Do i have to use IO device when pnpn coupler, or are there other ways? Because i think IO device way is having some limitations? If im not misstaken, you can send/receive only limited amounts of bytes?
Mr. Jimmy is this possible to communicate between S7-1200 and S7-200 smart master slave setup help of (S7-200 Smart GSD file) Not using get put Instruction block 🛑 ☺️
Nice but music is too loud my friend
Thanks mate, saved me with this!
Thank you for this tutorial, i was trying the same thing for the last few days. I watched many videos about this and everyone skipped the cruical step where you have to input the correct input/output addresses in master project. Many thanks and keep up the good work.
Thank you for your comment and watching my video :)
@@jimmyplc7613 hi. Is there any difference if i add a PN/PN coupler compared to your way?
@@genantamtam9364 PN/PN Coupler can be used in the different network between two PLCs. in this case, two PLCs are connected in same network.
@Jimmy PLC ok. Do i have to use IO device when pnpn coupler, or are there other ways?
Because i think IO device way is having some limitations? If im not misstaken, you can send/receive only limited amounts of bytes?
@@genantamtam9364 I think, pnpn coupler with IO device is good solution. And, IO device spend physical I/O address area.
Awesome, thanks.
Great!!!
Mr. Jimmy is this possible to communicate between S7-1200 and S7-200 smart master slave setup help of (S7-200 Smart GSD file)
Not using get put Instruction block 🛑 ☺️