Hi, if im using a 4 pole 230v/50hz(uk mains) 1400rpm motor with this drive and set p-01 to 100hz will the motor run at 2800rpm? ...more importantly will this damage the motor? I have p-07/08/09 already set to 230v/5.7a/50hz cheers ant :)
Hello there, thanks for this video.. I am a student at University and trying to control the VRF motor though labVIEW program; Optidrive E is connected with CPU through speedy.. I am following the instruction on manual to connect through modbus ( P0 12 and 4) ( Modbus network control) Problem facing right now.. 1. Trying to put it on default setting as explained in this video.. but it only set to default when control terminal 1 is disconnect and show the 'stop' message as it shows in video.. However, it goes back to previous setting, after, connecting the Terminal 1 (T1).. 2. can you please share the documentation to connect through speedy.. ? Thanks!
Hi, my drive suddenly didn't function anymore, so i've reset to factory settings and reconfigured all parameters. But...for F12 ( 4:55 in the movie ) i can't change the digit ( is on "0" now ) When I press up or down the "0" remains and the first digit of the screen shows additional an "L" as long i push the up or down button....What can be the cause of that? Thx
Please advise about Potensiometer how about K Ohm for value ?
What is the resistance of a 7.5 k invertek
Hi, if im using a 4 pole 230v/50hz(uk mains) 1400rpm motor with this drive and set p-01 to 100hz will the motor run at 2800rpm? ...more importantly will this damage the motor? I have p-07/08/09 already set to 230v/5.7a/50hz cheers ant :)
Hello there, thanks for this video.. I am a student at University and trying to control the VRF motor though labVIEW program; Optidrive E is connected with CPU through speedy..
I am following the instruction on manual to connect through modbus ( P0 12 and 4) ( Modbus network control)
Problem facing right now..
1. Trying to put it on default setting as explained in this video.. but it only set to default when control terminal 1 is disconnect and show the 'stop' message as it shows in video.. However, it goes back to previous setting, after, connecting the Terminal 1 (T1)..
2. can you please share the documentation to connect through speedy.. ?
Thanks!
I am looking forward for reply?...
Hi, my drive suddenly didn't function anymore, so i've reset to factory settings and reconfigured all parameters. But...for F12 ( 4:55 in the movie ) i can't change the digit ( is on "0" now ) When I press up or down the "0" remains and the first digit of the screen shows additional an "L" as long i push the up or down button....What can be the cause of that? Thx
Hi. If you visit our website, www.invertekdrives.com you will be able to contact your local sales partner who can advise on technical issues.
Very useful..thank you
can this drive control Teco 3 phase motors. Moreover, what is the difference between E2 and E3 version?
Muaathe Aziz jh
I have a question
Displayed 0=t what this problem
plis indonesia subtitel